About Us
Contact Us
Privacy Policy
Cookie Usage
Add Your Store

More From Contributor

image missing
LM348N Op-Amp LM348N
NSC
£1.00
A low power quad version of the 741 op-amp featuring high gain & internal compensation with a total supply current requirement for the IC that is less than a single conventional 741. Each op-amp has a class AB output stage & so has virtually no crossover distortion. Additional features include a low input offset voltage 1m V low input offset current typically 4n A low input bias current typically 30n A & a unity gain bandwidth of 1 M Hz. Channel separation is 120d B with a maximum operating voltage of plusmn 18 Vdc. ...
Archived Product
image missing
LM35 Precision
Centigrade Temperature
Sensor LM35DZ
£2.48
A precision integrated circuit with an output voltage that is linearly proportional to the Centigrade temperature. The advantage over the LM335Z is that it is not necessary to subtract a large constant voltage from the output to obtain the Centigrade scale. The chip does not require any external calibration to achieve accuracies of plusmn 410 deg C at room temperature & plusmn 810deg C over full temperature range. The device draws only 56micro A from voltage supplies in the range 4V to 30V so it has very low self-heating lt 0.1deg C in still air. The LM35DZ oerates in the range 0 C to 100 C. Specifications Oerating range 0deg C to 100deg C plusmn 0.9deg C Non-linearity 0.2deg C Sensor slope 10m Vdeg C Load regulation 0.4m Vm A Line regulation 0.01m Vm A Quiescent current 56micro A at VS 5V56.2micro A at VS 30 V Temperature co-efficient ofquiescent current 0.39micro Adeg C Output impedance 0.1micro with 1m A load ...
Archived Product
image missing
LM380N LM380N
£1.73
An audio amp in a 14-pin DIL package that requires very few external components to make a complete 2.5W power amplifier. In most cases however it is advisable to add a Min Res 2.7 Omega & Polyester 0.1micro F in series from pin 8 to ground & an Axial 4.7micro F from pin 1 to ground. High-Output-Crystal-Cartridge Power Amp A 2.5W rms power amp the 380 is shown in the circuit driven by a high output crystal pickup. The IC requires only 4 other components without tone control only two other components simply omit C1 & RV1. ...
Archived Product
image missing
LM386N-1 LM386N-1
£1.42
A power-amp designed for use in low voltage especially battery-operated applications such as AM-FM radios portable tape cassettes intercoms power invertors etc. For minimum parts count C1 & C2 can be omitted. With pins 1 & 8 open circuit the gain is internally set to 20d B. With a 10micro F capacitor between pins 1 & 8 the gain is increased to 200d B & the gain can be set to anything between these limits by placing a resistor in series with this capacitor. For example a 1k 2 resistor here sets the gain to 50d B. The capacitor on pin 7 sets the power supply rejection ratio from 6d B with no connection to 50d B at 1k Hz with 10micro F. The inputs are referenced to ground while the output is automatically biased to half the supply voltage. Specifications Maximum supply voltage 15 Vdc Quiescent current 4m A Output power with 8 Omega load 325m W 6V supply THD at 125m W with 8 Omega load 0.2 6V supply Bandwidth 300k Hz Input resistance 50k Omega ...
Archived Product
image missing
LM3914 Bargraph
Display LM3914N
£4.70
An LED driver that will sequentially light ten LEDs when a gradually increasing voltage is applied to pin 5 dot mode or in bar mode all LEDs indicating voltages below input are lit. In dot mode there is a slight overlap so that at no point are all LEDs extinguished. A brightness control will set LED current between 2m A & 30m A. The drivers are stackable & displays with 100 or more LEDs are possible. Supply voltage 3V to 18V. The driver that sets the indication points can be referenced to a wide range of voltages. The LM3914 is available with linear steps. ...
Archived Product
image missing
LM393N LM393N
£0.76
An independent precision voltage comparator designed specifically to operate from a single power supply over a wide range of voltages. Operation from split rails is possible & the low power supply current drain is independent of the magnitude of the power supply voltage. Unique to the LM393 is that the input common-mode voltage range

Includes:: ground even though operated from a single power supply voltage. Designed to directly interface with TTL & CMOS & when operated from a
- supply will directly interface with MOS logic. The device is similar to the 392 but offers much lower input offset voltage & draws only half the supply current.


...
Archived Product
image missing
LM567CN Tone
Decoder Phase Locked
Loop LM567CN
£0.76
Features
- Wide frequency range 0.01 Hz to 500k Hz
- High stability of centre frequency
- Independently controllable bandwidth


...
Archived Product
image missing
LM723C Variable
Voltage Regulator
LM723 DIL14
£0.76

- 150m A output current without external pass transistor
- Output currents in excess of 10A possible by adding external transistors
-


...
Archived Product

LM3900N LM3900N ROHS


- 4 dual input internally compensated amplifiers designed primarily for single power rail operation
- Current differencing amplifiers use a current mirror to achieve the non-inverting function When driving from a low impedance source a resistor

RIP - This product is no longer available on our network. It was last seen on 05.12.2012

This page now acts as a permanent archive for this product. Add more information using the comments box below to ensure it can still be found by future generations.

Use our search facility to see if it is available from an alternative contributor.
  • Availability: Out Of Stock
  • Supplier: Maplin
  • SKU: 220304N25CG
Availability: In Stock
£0.76
electronic components Electronic Components
Description Reviews / Comments Add New

Product Description


- 4 dual input internally compensated amplifiers designed primarily for single power rail operation
- Current differencing amplifiers use a current mirror to achieve the non-inverting function When driving from a low impedance source a resistor should be placed in series to limit the peak input current to less than 20m A. Absolute max ratings Supply voltage range 4V to 32V orplusmn 2V to plusmn 16 V Power dissipation max.570m W Input current max.20m A Typical ratings at 25deg C Open loop voltage gain 70d B Input resistance 1MOmega Out resistance 8 Omega Unity gain bandwith 2.5 M Hz Input bias current 30n A Slew rate positive output swing 0.5 Vmicro S Slew rate negative output swing 20 Vmicro S Supply current 6.2m A Output voltage swing 29.4 V Output current capability Source 1.8m A Sink 1.3m A Power supply rejection ratio 70d B Mirror gain 1micro Amicro Aplusmn 10 Mirror current 10micro A500micro A max Negative input current 1m A Full power bandwith 35k Hz

Reviews/Comments

Add New

Intelligent Comparison

Oooops!
We couldn't find anything!
Perhaps this product's unique.... Or perhaps we are still looking for comparisons!
Click to bump this page and we'll hurry up.

Price History

Oooops!
We couldn't find any historical pricing!

Vouchers

No voucher codes found.
Do you know a voucher code for this product or supplier? Add it to Insights for others to use.

Facebook

Jargon Buster

Voltage - A measurement of volts.

Supplier Information

Maplin
The UK's largest supplier of specialist and retail electronics. 172 stores nationwide and online shop, Maplin has over 15,000 products selling everything from MP3 Players and Sat Navs to digital cameras and Computer Equipment.

Trading since 1972 Maplin have a stonrg reputation as a supplier with the expertise and products as chosen by professionals.
Page Updated: 2012-10-13 03:02:54

Community Generated Product Tags

Lm3900n wiki (1 person tagged the product this way)
Menu