More From Contributor

The LANC Control Cable controls cameras with a LANC port, such as the BMCC, Sony FS5, or Sony FS7, by connecting them to the RSS port on the Ronin 2's Power Hub. ...

Available

The Ronin 2 Mitchell Mount Adapter can be used together with the Ronin 2 Universal Mount to install the Ronin 2 on a carrier, such as a jib or dolly, with a Mitchell mount. The adapter has M8, 8mm, 1/4”-20, & 3/8”-16 holes, allowing other compatible devices to be attached. ...

Available

Use the Motion Block when shooting at high-speeds for enhanced gimbal performance. ...

Available

Use the Pan Axis Quick-Lock to lock the pan axis in place when Ronin 2 is working in Pan Lock mode. ...

Available

The Ronin 2 Power Cable allows remote mounting of the Dual TB50 Battery Mount. Connect the power cable from the DC Out port on the Battery Mount to the DC In port on the Ronin 2. ...

Available

Upgraded high torque motors allow it to support a wider range of cameras, resist high winds & G-forces caused when mounted to a car & keep it moving smoothly in flight. ...

Available

Upgraded high torque motors allow it to support a wider range of cameras, resist high winds & G-forces caused when mounted to a car & keep it moving smoothly in flight. ...

Available

Use the Ready Rig Quick Connector to connect a Ready Rig & Ronin 2 Grip or other devices with a tube diameter of 25 mm or 30 mm. ...

Available

The RED Power Cable powers a RED camera by connecting the DC IN port on the camera to the 14.4V Accessory Power Port on Ronin 2's tilt axis. ...

Available

The RED RCP Control Cable controls a RED camera by connecting the CTRL port on the camera to the RSS Port on Ronin 2's Power Hub. ...

Available

DJI Ronin 2 Power Hub

The Ronin 2 Power Hub provides 3 industry standard power/data connectors, powering accessories at 14.4V. These rear facing ports not only provide power but are also able to transmit data.