The real Northrop F-5E Tiger II are part of a family of widely used light supersonic fighter aircraft, designed & built by Northrop in the United States, beginning in 1960s. Hundreds remain in service in air forces around the world. The F-5E " Tiger II" was a greatly enhanced version of the earlier F-5A " Freedom Fighter". Redesigned as a highly maneuverable, lightweight & inexpensive air superiority fighter, the E featured an air-to-air fire control radar system & a lead computing gun sight. More powerful J85 engines required the fuselage to be both widened & lengthened. The forward wing root was redesigned to give the " Tiger II" wing its characteristic triple delta shape. This excellent model is based on the US Navy desert camo finish. The real F-5E Tiger IIThis F-5E is one of the highest spec & quickest jets on the market. It is a massive 1.3m in length & is fitted with a 70mm EDF. Extra power & speed is produced by the big 14.8V, 2200mah Li Po battery & 40A brushless setup. As well as extra power & speed this jet also features an automatic landing gear system & turning front wheel. To allow this the set
Includes:: a 5ch transmitter & eight servos. It's a highly maneuverable model that can easily perform inverted flight, loops & rolls etc. The model comes pre-painted with everything you need included apart from the normal AA batteries for the transmitter. The model is almost ready to fly out of the box with only very minor assembly required such as attaching the wings. Everything you need to complete is included in the box. Included is a 5ch 1000m range transmitter, electronic speed controller, ducted fan with electric brushless motor & 8 electric servos all pre-installed. The 5ch transmitter gives full 3D control of the aileron, elevator, rudder, throttle & retracts. The 70mm ducted fan system with the brushless motors & li-po battery gives enormous power pushing the jet to crazy speeds. The high power allows full aerobatic characteristics & inside loops, outside loops, axial rolls, inverted flight, knife edge, stall turns, hammerheads, & spins are all possible. The attention to detail from Starmax who are the leading rc jet manufacturers gives the jet a nice realistic appearance. The jet can take off from the ground or can be hand launched. If you are not ready to be flying at high speeds then you can also fly the plane very slowly while you get used to it without any problems. The jet is made from shock resistant EPS foam with reinforced fuselage & strong wings. Should you need any spare parts though they are all available from our site. This plane is a lot of fun & you will certainly enjoy flying this fantastic model. Specification: Wingspan: 760mm Length: 1312mm Flying Weight: 900g Wing area: 12.44dm 2 Wing Load: 72.3g/dm 2 Radio System: 5 Ch Tx & 6 Ch Rx Servos: 8 x 9 gram servos Fan: 70mm Ducted fan Motor: Powerful 2836 out runner brushless ESC: 40A ESC 5A UBECBattery: 2200 Mah, 14.8 V Radio Control Range: 3000 feet (1000m)
Features:70mm EDFUpgraded 14.8V battery Working retracts 5 Channel Digital Proportional Full aerobatic characteristics Brushless setup Ready to fly in just minutes Super tough, lightweight airframe Perfect appearance & emulation Take off from ground or hand launched Excellent flight performance Stable inverted flight Made by Starmax
- industry leaders in qualit