This switch provides 16 10/100 Mbps ports to connect to 16 workstations & servers. All ports auto-sense the network speed of the computers & hubs to run at either 10 Mbps or 100 Mbps. All ports auto-negotiate between full & half duplex, flow control, & MDI/MDIX twisted-pair cross over. This switch provides an open slot for you to install 2 optional Fast Ethernet fiber ports to attach to 2 servers or cascading switches over the 2 km long reliable fiber cables. Expansion is easy through any twisted-pair port. You cascade several switches together through this port to get more ports. IEEE 802.3x Flow Control allows your servers to directly connect to this switch for fast, reliable data transfer. At 200 Mbps full duplex, this switch provides high-speed data pipes to your servers with minimum data transfer loss. Auto-negotiation of MDI/MDIX cross over eliminates the need for cross over cables or uplink ports. Any port can simply plug to a server, workstation, or hub using the usual straight through twisted-pair cable. ...

The D-Link DES-1018P/DES-1018MP 18-Port Fast Ethernet Po E Switches with 2 Gigabit Uplink Ports enables users to easily connect & supply power to Po E-capable devices such as wireless access points (APs), network cameras & IP phones. They can also connect other Ethernet devices like computers, printers & network attached storage (NAS) to fit into any type of network application. ...

The D-Link DES-1018P 18-Port Fast Ethernet Po E Switch with 2 Gigabit Uplink ports enables users to easily connect & supply power to Po E-capable devices such as wireless access points (APs), network cameras & IP phones. The DES-1018P can also connect other Ethernet devices like computers, printers & network attached storage (NAS) to fit into any type of network application. The DES-1018P features 8 ports that support the IEEE 802.3af Po E protocol. Each of the Po E ports can supply up to 15.4 watts, with a total Po E budget of 80 watts, allowing users to attach an IEEE 802.3af-compliant device to the DES-1018P without requiring additional power. Po E is especially suitable for devices that are far from power outlets or when users want to minimize the clutter of extra cables as power is supplied via the Ethernet cables themselves. The addition of 2 Gigabit combo uplink ports means businesses can increase their network bandwidth via wired speed while offering redundancy so voice & surveillance data are transferred reliably. The combo design can increase bandwidth by offering two Gigabit copper or fiber connections, giving administrators more options for expansion. To help small businesses save on operating costs, the DES-1018P supports IEEE 802.3az Energy Efficient Ethernet (EEE). This feature senses network traffic to automatically put ports that are not being used to sleep & also powers them on as required. The DES-1018P is a plug & play device that requires no configuration, so setup is simple & hassle-free. Simply connect the switch to a network to connect multiple computers, share files & make Vo IP calls. Support for Auto MDI/MDI-X on all ports eliminates the need for crossover cables when connecting to another switch or hub. Auto-Negotiation on each port senses the link speed of a network device (either 10 or 100) & intelligently adjusts for compatibility & optimal performance. Combining the convenience of Po E, fast performance, rel ...

The D-Link DES-1018P/DES-1018MP 18-Port Fast Ethernet Po E Switches with 2 Gigabit Uplink Ports enables users to easily connect & supply power to Po E-capable devices such as wireless access points (APs), network cameras & IP phones. They can also connect other Ethernet devices like computers, printers & network attached storage (NAS) to fit into any type of network application. ...

D-Links DFE-530TX Fast Ethernet adapter is a high-performance auto-sensing 10/100 Mbps dual-speed adapter for the PCI bus. The adapter operates in the 32-bit Bus Master mode, delivering throughputs at multi-megabits per second with little stress on hosts CPU. Network administrators can install optional boot ROMs on the adapters to implement network security. Diskless workstations equipped with these ROMs can remote boot from Net Ware or Windows NT servers & access authorized data. The adapter supports all major network operating systems, including Net Ware, Windows & Linux. ...

The DFL-1600 VPN Firewall delivers complete network protection & Virtual Private Network (VPN) services for large businesses. Through robust security features, flexible configuration & maximum network protection, it offers a high return on investment to businesses that demand high performance at competitive prices. Within an industrial chassis, the DFL-1600 VPN firewall offers an impressive set of hardware features that include a high-speed processor, a large database & a powerful firewall engine that can handle up to 400, 000 concurrent sessions. The DFL-1600

Includes:: multiple user-configurable Gigabit ports for flexible, scalable & cost effective network deployments with fail-over & outbound load balancing 1. In addition, two DFL-1600 firewalls can be installed in parallel for redundancy: the passive one serving as back-up in case of the failure of the active one (High Availability). 1functionality available in an upcoming firmware update The DFL-1600

Includes:: a special feature called Zone Defense
- a mechanism that operates seamlessly with D-Link x Stack switches to perform proactive network security. Zone Defense automatically quarantines infected computers on the network & prevents them from flooding the network with malicious traffic. The DFL-1600 offers two levels of Intrusion Prevention:
- Basic: countering well-known threats & periodically updated, this level is included free of charge.
- Advanced: using component-based signature technology, designed to detect unknown network attacks (zero-day protection) & updated in real time via the D-Link Net Defend Centre, which is included free of charge for a 3 month period & which is then available after this time as a purchase subscription. The DFL-1600 provides advanced traffic shaping technology, allowing administrators to prioritise & differentiate network traffic & set bandwidth limits. Furthermore, the DFL-1600 supports Server Load Balancing (SLB), which allows network service deman






...

The D-Link DGE-528T is a high-performance 10/100/1000 Mbps copper Gigabit PCI card for desktop PC. Capable of running at full-duplex Gigabit speed, this card gives your PC 2000 Mbps data transmission on your existing Cat. 5 twisted-pair network cable. As an inexpensive alternative solution to fiber-optic, the card means that you can instantly upgrade to Gigabit without requiring you to install new, expensive fiber cables. The card supports 10/100/1000 Mbps network speed auto-sensing & full/half duplex auto-negotiation. The card provides on-board screening of VLANs Tagged Ethernet frames, allowing your PC to be configured with VLAN-supported switch. Your PC can be part of a VLAN network, where domains are segmented up to enhance performance & security. Wake-On-LAN (WOL) is an Advanced Configuration Power Interface (ACPI) function allowing a powered OFF computer to be powered ON from a remote station. This function allows the administrator to send wake-up signals to a computer. The WOL function provides a great utility for power management of the PC & allows users to initiate action at irregular times & from distant locations. The cards embedded flow control & independent FIFO provide a means to protect against possible data loss during transmission on the network. When connected to a Gigabit switch supporting flow control, the card receives signals from the switch regarding buffer overrun during peak usage periods. The card then delays transmission until the switch is ready again to accept new data. Using a single chip solution, this card is very small in size & consumes very little power of your computer system. ...

The D-Link DGE-528T is a high-performance 10/100/1000 Mbps copper Gigabit PCI card for desktop PC. Capable of running at full-duplex Gigabit speed, this card gives your PC 2000 Mbps data transmission on your existing Cat. 5 twisted-pair network cable. As an inexpensive alternative solution to fiber-optic, the card means that you can instantly upgrade to Gigabit without requiring you to install new, expensive fiber cables. The card supports 10/100/1000 Mbps network speed auto-sensing & full/half duplex auto-negotiation. The card provides on-board screening of VLANs Tagged Ethernet frames, allowing your PC to be configured with VLAN-supported switch. Your PC can be part of a VLAN network, where domains are segmented up to enhance performance & security. Wake-On-LAN (WOL) is an Advanced Configuration Power Interface (ACPI) function allowing a powered OFF computer to be powered ON from a remote station. This function allows the administrator to send wake-up signals to a computer. The WOL function provides a great utility for power management of the PC & allows users to initiate action at irregular times & from distant locations. The card's embedded flow control & independent FIFO provide a means to protect against possible data loss during transmission on the network. When connected to a Gigabit switch supporting flow control, the card receives signals from the switch regarding buffer overrun during peak usage periods. The card then delays transmission until the switch is ready again to accept new data. Using a single chip solution, this card is very small in size & consumes very little power of your computer system. ...

The D-Link DGE-528T is a high-performance 10/100/1000 Mbps copper Gigabit PCI card for desktop PC. Capable of running at full-duplex Gigabit speed, this card gives your PC 2000 Mbps data transmission on your existing Cat. 5 twisted-pair network cable. As an inexpensive alternative solution to fiber-optic, the card means that you can instantly upgrade to Gigabit without requiring you to install new, expensive fiber cables. The card supports 10/100/1000 Mbps network speed auto-sensing & full/half duplex auto-negotiation. The card provides on-board screening of VLANs Tagged Ethernet frames, allowing your PC to be configured with VLAN-supported switch. Your PC can be part of a VLAN network, where domains are segmented up to enhance performance & security. Wake-On-LAN (WOL) is an Advanced Configuration Power Interface (ACPI) function allowing a powered OFF computer to be powered ON from a remote station. This function allows the administrator to send wake-up signals to a computer. The WOL function provides a great utility for power management of the PC & allows users to initiate action at irregular times & from distant locations. The card's embedded flow control & independent FIFO provide a means to protect against possible data loss during transmission on the network. When connected to a Gigabit switch supporting flow control, the card receives signals from the switch regarding buffer overrun during peak usage periods. The card then delays transmission until the switch is ready again to accept new data. Using a single chip solution, this card is very small in size & consumes very little power of your computer system. ...

D-Link's DGS-105 & DGS-108 Gigabit Ethernet switches provide a cost-effective way for small & medium sized businesses to create a small network & connect computers, wireless Access Points, IP cameras, network printers & other Ethernet devices quickly & easily without complicated configurations. These switches come with 5 or 8 Gigabit Ethernet ports with an auto-sensing function to detect the maximum speed of the connected devices, allowing you to run your network with the best possible performance. Their fanless design & solid metal housing makes them completely silent so they are ideal for offices, libraries or meeting rooms, & for industrial & hazardous environments like factories & warehouses. The DGS-105 & DGS-108 are designed with durability & performance in mind. Their sturdy metal housing will protect them against accidental harm, while helping to dissipate heat & to reduce stress on internal components. The LEDs allow for an easy reading of each port status & speed, helping to troubleshoot connectivity problems. For a convenient placement, these switches come with a wall mounting kit & a slot for a Kensington security lock to protect them from theft. Despite being unmanaged, Plug & Play switches, the DGS-105 & DGS-108 are able to classify network traffic by assessing the 802.1p field in the Ethernet frames, & forward them out of its ports depending on their priority. This allows for a smooth integration of video, voice & data traffic without delays or loss of quality. The cable diagnostics function enables users to quickly troubleshoot faulty network cables that may lead to transmission errors. At startup, the switch performs a micro-test to assess the quality of the cables connected to its ports. If a fault is detected, the ambar LED will lit up. If the cables pass the test, the green LED will be illuminated, indicating that the network is error-free. This feature can save valuable time when trying to single out ...