ELIMINATES & PREVENTS THE OILY FILM ON THE WATER SURFACE & ON THE WATERLINE.

Natural enzymes digest creams, lotions &

...

REMOVES SCALE & MINERAL STAINING. Effective on all types of pool surfaces. No unpleasant odour. Fi-Clor Stain & Scale Remover has been specially developed to help remove scale, rust stains & mineral deposits from pool surfaces, surrounds, showers & toilets. Equally effective on tiles & liners it quickly returns surfaces to look like new. Instructions: Wear gloves & eye protrection. > If possible, wet the surface to be cleaned. > When diluting, always add product to the water, never water to product. > Wipe on with natural sponge or smooth brush. > If necessary brush the surfaces being cleaned (avoid the use of synthetic brushes). Rinse with plenty of water. > For stubborn stains, repeat as required. ...

CORRECTS LOW TOTAL ALKALINITY. Fi-Clor Alkalinity Increaser (Bicarbonate) is for raising the total alkalinity level in swimming pool water. Alkalinity is a measure of the amount of alkali (or in chemical terms, bicarbonates & carbonates) in the water. If the alkalinity is too low, any chemicals added to the pool will directly affect the p H, causing rapid fluctuations in p H readings. Alkalinity at the correct level will help protect, or 'buffer' the p H. Instructions > Take an alkalinity reading on your test kit. You will need to raise the total alkalinity if the reading is below 100mg/l (ppm) for pools sanitised with stabilised chlorines or bromine, or below 80mg/l (ppm) for pools sanitised with Fi-Clor Superfast or Supercapsules. > Pre-dissolve the Fi-Clor Alkalinity Increaser in pool water using a suitable container. In order to avoid concentrated solutions, only dissolve a maximum of 500g of the product in 10 litres of water at a time, adding product to water, never water to product. Dose no more than a total of 1.5kg in a day. > With the circulation system running, distribute evenly around the pool, avoiding the skimmers. > Continue filtration & re-test after 24 hours. If the total alkalinity is still low, repeat the dose. ...

CORRECTS LOW CALCIUM HARDNESS. Fi-Clor Hardness Increaser is for raising the calcium hardness level in swimming pool water. Calcium hardness is the amount of dissolved calcium & magnesium in pool water. If there is insufficient dissolved calcium, the water will try & take it from the grouting & concrete in the pool. High levels are not a major cause for concern provided the p H & alkalinity are within recommended parameters, but the reading should be kept below 1000mg/l (ppm) if possible. Instructions > Take a calcium hardness reading using your test kit. You will need to correct the calcium hardness if the reading is below 175mg/l (ppm) for liner pools, & below 250mg/l (ppm) for tiled pools. > With the circulation system running, sprinkle the product directly into the water around the perimeter of the pool. Do not pre-dissolve as this could generate excessive heat. Only use when bathing has ceased, & avoid areas near the skimmers. > Re-test after 24 hours. If the calcium hardness level is still below 175mg/l (ppm) for liner pools, & 250mg/l (ppm) for tiled pools, repeat the dose. ...