The Flexible Swimming Pool Vacuum Head with Brushes is suitable for concrete pools. It has a wide flexible design which hugs the pool floor & bends to access the pool curves for extra pool cleaning power. It also has tough brushes on each end which will help with the cleaning process. This universal vacuum head will connect to the majority of standard swimming pool poles & swimming pool vacuum hoses. ...

This large capacity dispenser holds up to 1.3kg of 3 inch (200g) chlorine tablets. It comes with an adjustment ring to control

...

REMOVES SCALE & MINERAL STAINING. Effective on all types of pool surfaces. No unpleasant odour. Fi-Clor Stain & Scale Remover has been specially developed to help remove scale, rust stains & mineral deposits from pool surfaces, surrounds, showers & toilets. Equally effective on tiles & liners it quickly returns surfaces to look like new. Instructions: Wear gloves & eye protrection. > If possible, wet the surface to be cleaned. > When diluting, always add product to the water, never water to product. > Wipe on with natural sponge or smooth brush. > If necessary brush the surfaces being cleaned (avoid the use of synthetic brushes). Rinse with plenty of water. > For stubborn stains, repeat as required. ...

CORRECTS LOW TOTAL ALKALINITY. Fi-Clor Alkalinity Increaser (Bicarbonate) is for raising the total alkalinity level in swimming pool water. Alkalinity is a measure of the amount of alkali (or in chemical terms, bicarbonates & carbonates) in the water. If the alkalinity is too low, any chemicals added to the pool will directly affect the p H, causing rapid fluctuations in p H readings. Alkalinity at the correct level will help protect, or 'buffer' the p H. Instructions > Take an alkalinity reading on your test kit. You will need to raise the total alkalinity if the reading is below 100mg/l (ppm) for pools sanitised with stabilised chlorines or bromine, or below 80mg/l (ppm) for pools sanitised with Fi-Clor Superfast or Supercapsules. > Pre-dissolve the Fi-Clor Alkalinity Increaser in pool water using a suitable container. In order to avoid concentrated solutions, only dissolve a maximum of 500g of the product in 10 litres of water at a time, adding product to water, never water to product. Dose no more than a total of 1.5kg in a day. > With the circulation system running, distribute evenly around the pool, avoiding the skimmers. > Continue filtration & re-test after 24 hours. If the total alkalinity is still low, repeat the dose. ...

Suitable for all types of sand filtration. Compatible with all pool santisers.

There can be a number of small particles

...