United Kingdom
France
Germany
Netherlands
Sweden
USA
Italy
Spain
More From Contributor
Kingston KVR16LS11/8 RAM 1600 MHz DDR3L Non-ECC CL11 SODIMM - 8GB
Kingston ValueRAM's 1G x 64-bit (8GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM), 2Rx8, memory module, based on sixteen 512M x 8-bit FBGA components. The SPD is programmed to JEDE standard latency DDR3-1600 timing of 11-11-11 at 1.5V. This 204-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows: - JEDEC standard 1.35V (1.28V ~1.45V) and 1.5V (1.425V ~ 1.575V) Power Supply - VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) - 800MHz fCK for 1600Mb/sec/pin - 8 independent internal bank - Programmable CAS Latency: 11, 10, 9, 8, 7, 6 - Programmable Additive Latency: 0, CL - 2, or CL - 1 clock - 8 -bit pre-fetch - Burst Length: 8 (Interleave without any limit, sequential with starting address â000â only), 4 with tCCD = 4 which
does not allow seamless read or write [either on the fly using A12 or MRS] - Bi-directional Differential Data Strobe - Internal(self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm ± 1%) - On Die Termination using ODT pin - Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C TCASE 95°C - Asynchronous Reset - PCB: Height 1.18â (30mm), double sided component
does not allow seamless read or write [either on the fly using A12 or MRS] - Bi-directional Differential Data Strobe - Internal(self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm ± 1%) - On Die Termination using ODT pin - Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C TCASE 95°C - Asynchronous Reset - PCB: Height 1.18â (30mm), double sided component
Denmark