Enables virtually any audio device to be played through your FM enabled car-stereo Terminated in two phono sockets for input Powered from the car battery Pass-through FM aerial connector This handy device allows almost any audio device to be played through FM reception on your car stereo. There are three sets of connectors that run off the modulator. The first is a pair of phono sockets which are used for audio input from your chosen audio player. If your audio player only has a 3.5mm output socket as typically used for headphones you may also require a 3.5mm to two phono plugs adaptor lead Maplin Order Code L32BA. Secondly there are power & ground wires with an in-line power filter noise suppressor. Finally there is a skeleton-type aerial plug & socket. The plug is inserted in to the car stereo aerial input socket & the socket is used to house the input from your existing car aerial. A panel-mounting remote onoff switch is also included to allow for easy operation of the unit from the dashboard console of the vehicle. This will require a small cut-out to be made in the dashboard for the switch to sit in & this must be connected for the unit to be powered. The output level can be adjusted using a small cross-head screwdriver & the unit can be set to broadcast on one of two FM frequencies either 88.7 M Hz or 89.1 M Hz. ...

3 radial 58 collinear broadcast antenna for the VHF FM radio band Ideal for local hospital or community radio stations who need a low cost or low profile installation 88-108 MHz coverage & tuneable to your exact frequency allocation full cutting instructions included Can be used as a vertical antenna to improve reception for FM radio receivers ...

- Listen to your MP3 music on your car radio or hi-fi system
- Simply connect to the audio player & send your music to the

...

- Mounted vertically as shown the FM is an omni-directional aerial.
- Mounted horizontally it becomes directional
- useful


...