MPLA ICD 2 In-Circuit Debugger Programmer 12F ICD2 Adapter

Product Description

USB full speed 2 Mbitss & RS-232 interface to host PCReal-time execution MPLABandreg IDE compatible free copy included Built-in over voltageshort circuit monitor Firmware up-gradeable from PCweb download Totally enclosed Supports low voltage to 2V 2 to 6V range Diagnostic LEDs Power Busy Error Read Write program & data memory of microcontroller Erase of program memory space with verification Freeze-peripherals at breakpoint The MPLABandreg ICD 2 In-Circuit Debugger 2 allows debugging & programming of PICandreg & ds PICandreg FLASH microcontrollers using the powerful graphical user interface of the MPLABandreg Integrated Development Environment IDE included with each kit. The MPLABandreg ICD 2 is connected to the PC using USB (Universal Serial Bus) or RS-232 interface & can be connected to the target via an ICD connector that uses two device IO pins that are shared between the in-circuit debugging & In-Circuit Serial Programmingand 153. The MPLAB ICD 2 currently supports most PIC & ds PIC FLASH microcontrollers. FLASH PICmicro MCUs not supported are PIC16F72737476778384A. The ICD 2 is available as USB (Universal Serial Bus) version Order code N40BH or as a USBSerial RS-232 version Order code N32BH that

Includes:: Picdem 2 demo board & PSU. Also available are two accessories 1. 12F ICD2 Adaptor Order code N35BH
- allows ICD2 to emulate al 8-pins of 8-pin FLASH devices 2. ICD 2 Prog Module Order code N37BH
- Allows ICD2 to program all PIC micros B System requirements BPC-compatible system with Intel Pentiumandreg class or higher processor or equivalent A minimum of 32 Mb RAMA minimum of 40 Mb available hard drive space CD-ROM drive for use with accompanying CDAvailable USB (Universal Serial Bus) or RS-232 port Microsoftandreg Windowsandreg 98 Windows NTandreg 4.0 WIndows 2000 or Windows XP. USB (Universal Serial Bus) support may be limited by the Windows operating system particularly Windows 98NT