- Allows up to 2 appliances to be plugged into a standard 13A socket
- 3-pin adaptor 13 amp rating
- Shuttered sockets
-



...

- Used to replace a single LNB for a satellite installation with 2 receivers
- Watch different channels from the same satellite

...

feed two receivers from a single LNB. One of the outputs has DC pass & the receiver connected to this supplies power to the LNB. In the case of most systems this master receiver will also select polarity & thus determine the channels available to the slave receiver. Although an inexpensive method of running two receivers from a single dish it is not as flexible as a twin LNB which allows two receivers to select channels of either polarity independently. Frequency range 5 M Hz to 2 G Hz. To protect one receiver & its user if a fault should develop in the other this splitter has screw terminals for earthing. A splitter designed to ...

Run two sets of speakers from your hi-fi Switch on either set or both together Sturdy metal construction A two-way switch box for connecting a stereo power amplifier to two pairs of speakers that can be connected to the amplifiers output either separately or simultaneously. The unit is wired such that the minimum load presented to the amplifier is 4andohm when used with 8andohm speakers which is safe for most amplifiers. When both speakers are off the switch box presents a safe 220andohm load. Speaker connections are via spring-loaded terminals.

Dimensions 16.5x 9x 5cm.

...

Improve your TV picture especially in poor reception areas Twin outputs to boost the signal from your aerial to two televisions Ideal for digital Freeviewand 153 & analogue TV signals High gain level of 15d B per port
Includes: compact plug-in power adaptor
...

An inexpensive wired intercom ideal for situations where the stations are to be used in permanent positions. The two stations are connected by 20m of twin cable via 3.5mm mono jacks. The master station houses the 9V PP3 battery not supplied & has a socket for an external 9V supply. The stations can be wall mounted or free standing on a convenient surface. The master station is normally left switched off. To make a call the call key is pressed at either station a call signal will follow & the master station is switched on. To speak from the master station the calltalk key is held down & the LED lights up the key is released to listen to the substation. The LED on the substation will now light up & the substation can now speak to the master station without pressing a key. When the conversation is over the master station is switched off. A volume control is provided on the master station. Dimensions each 130x 90x 46mm. Supplied in pairs only. Cable clips included. ...