The punches & chisels in this set are manufactured form Chrome Vanadium. Contents include: 5 x Flat Chisels, 1 x Cape Chisel, 2 x Taper Punches, 2 x Pin Punches & 2 Centre Punches. The universal handle has a robust handle with hand protector & is manufactured from Chrome Molybdenum for extra strength. A blow mould case houses the set. ...

For use on Alfa Romeo Twin Spark 1.4/1.6 2.0 engines with engine codes 323.01, 672.04, 162.01, 323.10. ...

Camshaft setting/locking plates are used to accurately align a datum slot, located in the end of the camshaft, with the top face of the camshaft housing to hold the camshaft at the (TDC) Top Dead Centre position. Locking pins are designed to pass through datum holes in the timing belt pulleys into fixed position timing holes on the engine. The Crankshaft TDC Location Pin is designed to screw into the cylinder block & provide a stop for the crankshaft to be positioned against to set the TDC position. Crankshaft Locking Tools are used to set the crankshaft timing position during both removal & replacement of the timing belt. Flywheel Locking Tool is required on engines where the flywheel & crankshaft must be held at the correct timing position. This tool is used in conjunction with the appropriate TDC Setting Screw. ...

This tool is required on engines where the flywheel & crankshaft must be held at the correct timing position. After attaching the Flywheel Locking plate, the toothed profile is adjusted & locked after being fully engaged in the flywheel ring gear. Covers most engines in the Ford range (pre 2007) including both petrol & diesel & the Zetec engine. This tool is required on engines where the flywheel & crankshaft must be held at the correct timing position. After attaching the flywheel locking plate, the toothed profile is adjusted & locked after being fully engaged in the flywheel ring gear. ...

This special Alldrive Socket Set has a unique V type profile which fits HEX/MM/AF/STAR & SPLINE fixings. ...

Riveter & Riv Nut/ Riv Bolt set, with swivel head. One handed operation, with 360° swivel action. Suitable for: 2.4, 4.0 & 4.8mm rivets. Suitable for: M4, M5, M6 nut rivets; M4, M5 & M6 bolt rivets. Nut rivets & rivets available separately, please See Laser Part Nos. 0980
- 0983 & 1799
- 1802. Connect offer sets of assorted rivets, please see Part Nos. 31843 & 31844. Spare mandrils available
- please see Laser Part Nos. 2770 (M4), 2771 (M5) & 2772 (M6).


...

This Double Headed Parts Cleaning Brush has solvent resistant bristles & can be used with all degreasing fluids. ...

For use on Lambda sensors (oxygen sensors) on most modern cars. This tool covers a wide variety of options & fits most heated & non-heated sensors. ...

This tensioning gauge can be used to adjust the tension on the Cambelt where the movement of the timing belt is measured by load (Nm). ...

Black finished dropped forged & made from Chrome Vanadium for extra strength. Large printing for easy selection & complete with socket rail. ...