D-Link DIS-100G-6S 4 Ports Ethernet Switch
- 2 Layer Supported
- Modular
- Twisted Pair, Optical Fiber
- DIN Rail Mountable



...

30W 24VDC Ultra Slim DIN Rail PSU Input: 85 ~ 264VAC Output: 21.6 ~ 29V DC Din rail TS-35/7.5 or 15 mountable -30~70°C operating temperature Compatible with DIS-100G, DIS-300G ...

60W 24VDC Input: 85 ~ 264VAC Output: 21.6 ~ 29V DC Din rail TS-35/7.5 or 15 mountable -30~70°C operating temperature Compatible with DIS-100G, DIS-300G ...

DIS&8209;N240&8209;48 240W 48VDC DIN Rail PSU 240W 48VDC Ultra Slim DIN Rail PSU Input: 90 ~ 264VAC Output: 48 ~ 55V DC Din rail TS-35/7.5 or 15 mountable -20~70°C operating temperature Compatible with DIS-100G, DIS-300G ...

The DKVM-2KU 2-port mini KVM (Keyboard, Video & Mouse) switch means that you can easily control 2 different PCs from a single set of keyboard, mouse, & VGA monitor, & to share a USB (Universal Serial Bus) device with 2 PCs. It

Includes:: 2 sets of built-in cables for ready connection to 2 PCs. If you have 2 PCs & need to use them at the same time, the DKVM-2KU saves you the money & space by allowing you to control your 2 computers from a set of keyboard, monitor & mouse. Or, you may have a better, bigger monitor & want to connect both PCs to it, the DKVM-2KU means that you can do this. 2 sets of cables are attached to the KVM switch ready for use, dispensing you of the need to prepare separate cables & connect them to the switch. The DKVM-2KU supports VGA, SVGA, & Multi Sync monitors at up to 2048 x 1536 resolution at 72 Hz refresh rate. Support for Microsoft Intelli Mouse is provided. There is also a control button located on the front panel that means that you can switch between the PCs. A USB (Universal Serial Bus) 2.0 port is built into this KVM switch to allow connection to a USB (Universal Serial Bus)-supported device or a USB (Universal Serial Bus) hub. This means that you can share your USB (Universal Serial Bus) printer, scanner, card reader or other devices among the 2 connected PCs. Please note: networking components such as switches, routers, KVM & wireless devices require that speeds & standards be consistent throughout the network to gain optimum performance. To avoid compatibility clashes or for advice, please contact us on solutions@ebuyer.com.

...

The D-Link PS2/USB 16-port combo KVM switch DKVM-450 is a high-end local remote management solution which means that you can control PCs from a single console. Controls up to 16 PCs Supports daisy chaining with up to 3 cascade levels with no special configuration. On-screen Display (OSD) Keyboard emulation to prevent boot errors Hot-pluggable: no need to switch off the KVM to add more devices LED display for PC and/or server status monitoring Select a PC to switch to by using one of 3 interfaces: Front Panel Button Hot-Keys on a PS/2 keyboard OSD Menu (On Screen Display) ...

The D-Link DKVM-4K is a 4-port PS/2 based KVM switch for controlling up to 4 computers using a single monitor, keyboard, & mouse. The DKVM-4K minimizes clutter on your desktop with its sleek, compact design. Ready to work right out of the box, the DKVM-4K requires no drivers, extra power supplies, or accessories & is compatible with all Windows Operating Systems. The DKVM-4K is convenient & simple to use with features such as: at a glance LED indicators for computer status, hot keys & push buttons for switching between computers, included 6' standard cables, & an autoscan mode for automatically detecting computers connected to the switch. You get added flexibility with the DKVM-4K's hot plug capability
- add or disconnect computers simply by unplugging the cables without having to power down your computers! Versatile, portable, & convenient, the D-Link DKVM-4K can be easily integrated into your existing desktop environment at home or in the office.
...

The DKVM-CB Keyboard, Video, & Mouse (KVM) cable is a 6-foot (1.8m) cable that is compatible with D-Link DKVM series KVM Switches. It is also compatible with most KVM switches available on the market today. Each end of the cable

Includes:: a keyboard & mouse connector (6 pin Mini-Din Male) & a video connector (15 Pin HDD Male). The Video cable is designed to ensure the highest quality of video over a KVM switch connection. The DKVM-CB is an all-in-one cable that minimizes desktop clutter by combining each cable into one convenient package. Each cable end is color-coded (PC99) to ensure proper installation. Also, each cable is specially shielded with a ferrite core to reduce electromagnetic (EMI) & radio frequency interference (RFI).

...

These converters convert 10/100 Mbps 10BASE-T/ 100BASE-TX Fast Ethernet twisted-pair signals to 100BASE-FX Fast Ethernet fiber signals. The media converters come with their own solid metal case housing, LED status indicators & AC to DC power adapters. They can be used as st&-alone converters, or installed in a DMC-1000 chassis. In case you install them in the chassis, you will remove their metal cases & slide in their PC boards into the chassis slots. The chassis's power supply will be used instead of the media converters' own AC to DC power adapters. All media converters are hot-swappable when used with the chassis. ...

The DNR-2020-04P Just Connect 16-Channel Po E Network Video Recorder is an all-in-one network video recorder (NVR) that can record video from up to 16 network cameras to its dual HDD storage. With the integrated HDMI/VGA display output & USB (Universal Serial Bus) port, users can view, control & configure the DNR-2020-04P without the need to turn on their PC. Technical Specifications General Standards IEEE 802.3u/x/z IEEE 802.3af SATA II/III Auto MDI/MDI-X HDD2 Format Disk Up to 16 TB HDD EXT3 file system RAID 0, 1, JBOD4 Two Reset Modes Reset firmware GUI button HW reset button (hold for 10 seconds) Reset Button Reset to factory default Flash ROM 128 MB RAM 1024 MB DDR3 Network Interface Gigabit Ethernet port (10/100/1000 Mbps) I/O Ports 1 x 10/100/1000 Base T RJ-45 port 4 x 10/100 Base T Po E port (802.3af) HDMI (supports 720p & 1080p resolution with 16:9 display ratio) D-sub for VGA output 1 x USB (Universal Serial Bus) 3.0 port 3 1 x USB (Universal Serial Bus) 2.0 port 3 3.5 mm audio input x 1, output x 1 4 x DI, 1 x DO Cooling 1 x Smart Fan Software Features Supported Cameras Please visit www.dlink.com for a list of supported cameras 1 Supports auto-discovery & megapixel resolution System Requirements for Web Interface Browser: Internet Explorer, Firefox, or Safari Recording Performance Max recording bitrate: 80 Mbit/s Primary video profile: H.264 at 1080p at 480 fps Secondary video profile: H.264 at VGA at 240 fps Camera Search UPn P ONVIF Audio & Video Recording Synchronised audio & video recording Compression Format H.264, MPEG-4, M-JPEG Audio Compression Format G.711, G.726 Video Setting Resolution Quality Bitrate Frame rate Enable audio Video profile selection Recording Mode Record by schedule, manual, always, & event-based recording Motion-triggered recording Alarm Recording Pre-alarm: 60 seconds per channel Post-alarm: 300 seconds per channel Remote Live View Supported via browser & Multi NVR Viewer (DCS-260) software Remote Live View Control Live view Preset/ Go to Preset Patrol/ Auto Patrol Focus PTZ control Snapshot Full screen Auto scan Digital zoom (Zoom in & Zoom out) Manual Record Audio Enable Adjust audio volume Video layout e-map Remote Playback Control Normal Fast forward/rewind Step forward/rewind Remote Playback Supported via browser & Remote Playback application Playback system with timeline GUI, search by event, area, cameras, date, & time Browser or Remote Playback support 16-channel simultaneous playback Digital zoom Overwrite Recording Auto recycling when disk storage is full File Export Local: Export videos to AVI / MP4 format Remote: Export videos to AVI or ASF file Export images to JPG file Digital Watermark Tool Prevents recorded video files/snapshots from being tampered with Acts as a tool for verification User Account Additional accounts can be created to allow users system access & specify authorization for camera channels, PTZ, etc. DDNS D-Link DDNS & Dyn Dns server support Manual DDNS System Time D-Link NTP Input time Sync with computer Daylight saving time Auto Backup Backup recorded data to USB/SAMBA/FTP via a schedule Remote Backup Remote backup software can backup raw data to redundant storage System Status Camera status HDD status System status Network Service Protocols IPV4, ARP, TCP, UDP, ICMP DHCP Server/ Client NTP Client DNS Client DDNS Client SMTP Client FTP Client HTTP Server RTP RTCP RTSP IP filtering UPn P Co S Qo S/DSCP HTTPS Samba Bonjour SNMP v 1/v 2c/v 3 PPPo E DDP User Interface HTTP Web browser NVR Search Utility Remote Playback/ Backup Verification tool Mobile app (Just Connect+ Mobile App available on i Tunes & Google Play) GUI via HDMI/VGA Package Contents Just Connect 16-Channel Po E Network Video Recorder Power Adapter Ethernet Cable Quick Installation Guide CD-ROM with: Software Product Documentation Physical Weight 2.1kg (4.63 lbs) Power Input Input: 100 to 240 V AC, 50 to 60 Hz Output: DC 48 V/1.85 A Power Consumption Max. 90 W Po E Budget Per Port: Max. 15 W Total: 45 W Temperature Operating: 0 to 40 &730;C (32 to 104 &730;F) Storage: -20 to 70 &730;C (-4 to 158 &730;F) Humidity 5% to 90% non-condensing Certifications CE FCC Ro HS Dimensions 63 x 225 x 300 mm ...