More From Contributor

Aluminum parapet mount including AXIS T94A01D Pendant Kit (only used in combination with PTZ cameras) and AXIS T91A6 Pipe Seal. Also compatible with Axis pendant kits with 1.5” NPS or NPT inner thread, & Axis ACI 3/4” conduit adapters. The cables can be routed through the back, or from the side by using a conduit connection. ...

Available

Compatible with AXIS PTZ dome & fixed dome network cameras. Also suitable for installation with conduit connections & cable channels. AXIS T94A01D Pendant Kit & AXIS T91A6 Pipe Seal are included. ...

Available

Robust & safe pole installation Suitable for indoor & outdoor use Impact-resistant to prevent vandalism Cable gasket to prevent insect infestation Support for 1.5" NPS threaded Axis pendant kits The outdoor-ready AXIS T91B67 Pole Mount has a 1.5" NPS threading for a wide range of Axis pendant kits for Axis fixed dome & panoramic cameras. Thanks to its impact-resistant & outdoor-proven material, the mount can be used in both indoor & outdoor environments. AXIS T91B67 is intended for poles with a diameter between 65–165 mm (2 1/2–6 1/2 in), & also for beams. It features 3/4" conduit side entries for protected cable runs, & a closed back with cable gasket for protection against insect infestation. The pole mount is tightened with two marine-grade (SS316L) stainless steel straps with TX30 screw interface for ease & secure installation. ...

Available

Aluminum wall mount with 1.5& Prime; NPS thread. Compatible with Axis fixed dome pendant kits & Axis ACI 3/4” conduit adapters. The cables can be routed through the back, or from the side by using a conduit connection.
Includes: AXIS T91A6 Pipe Seal.
...

Available

AXIS T91E61 wall mount is specially designed for Axis fixed dome network cameras. The neat design is for both indoor & outdoor installations. Thanks to its impact-resistant & outdoor proven material, AXIS T91E61 wall mount suits all environments where Axis fixed dome cameras are used in. It is designed for being mounted with Axis cameras & gives a discreet look due to its small form factor. It is compatible with all Axis fixed dome pendant kits with a 1.5" NPS thread & can also be installed on AXIS T94R01P Conduit Back Box to enable use of cable protection conduits. AXIS T91E61 has the same hole pattern as the wall mount for outdoor fixed box Axis cameras to enable an easy switch. AXIS T91D61 wall mounts make sure that swapping two Axis cameras is as easy as possible. Moreover, it is possible to run the cable externally by using one of the four cut-outs in the base of the wall mount. ...

Available

Designed for fixed dome cameras, AXIS T91H61 Wall Mount accommodates & safely protects accessories inside the mount. You can connect the power & data quickly & easily thanks to the built-in RJ45 cable with connector. The wall mount is designed to be impact- & weather-resistant (rain, dust & corrosion), & it is suitable for all environments both indoors & outdoors. You can mount it on poles & corners with the help of optional accessories. ...

Available

Versatile connection with IDC connector Built-in IP66 RJ45 connector For wall & pole mounting Protection against impact, water, dust, & corrosion Versatile connection with RJ45 or IDC AXIS T91L61 Wall-&-Pole Mount gives the installer a choice of using either RJ45 or IDC (insulation-displacement contact) connector for the installation. It comes with a built-in cable with an Ethernet IP66 RJ45 connector, which facilitates the installation & prevents water & dust to enter the network camera. Flexible installation Thanks to its impact-resistant & outdoor proven material, AXIS T91L61 Wall-&-Pole Mount suits both indoor & outdoor environments. Flipping the mounting bracket makes it possible to turn AXIS T91L61 from a wall mount to a pole mount (AXIS Steel Straps TX30 are required). The mount is also suitable for corner mounting with an optional accessory. ...

Available

AXIS T92E20 Outdoor Housing features a dual shell technology, where an internal shell stores heat in cold environments. Fan ventilation for hot environments, where the heat is transferred to the outer chassis for efficient cooling. Operating conditions ranges between -30 °C to 60 °C (-22 °F to 140 °F) with Po E (IEEE802.3af) & down to -40 °C (-40 °F) with High Po E (IEEE802.3at). The Arctic Temperature Control allows the camera not only to function at -40 °C (-40 °F), but can also power up at that temperature following a power failure. ...

Available

Aluminum pendant kit for mounting the camera on 1.5 inch NPS threaded brackets. Included with AXIS T91A67 & AXIS T91B61, T91B62, T91B63. ...

Available

Outdoor recessed designed for AXIS Q60-E PTZ Cameras in roof overhangs/soffits. It is made from aluminum & stainless steel & it supports both safety standards & the impact resistance of the camera. It also offers two 3/4" conduit holes for a plenum and/or rodent safe installation. ...

Archived Product

AXIS T91G61 Wall Mount

Roomy compartment for protection and connectivity AXIS T91G61 Wall Mount is specially designed to accommodate and safely protect against water ingress inside the mount, such as midspans and media converters. The pre-mounted Ethernet cable with IP66 RJ45 connector (with gasket) helps quickly and easily connecting power and data to most of Axis PTZ network cameras. Beautiful and yet strong Thanks to its impact-resistant and outdoor proven material, AXIS T91G61 Wall Mount suits all environments, both indoors and outdoors. AXIS T91G61 has the same hole pattern as the standard Axis PTZ wall mount and for retrofit, a pattern that matches Pelcos PTZ camera mount to enable an easy switch - no additional drilling is required. Moreover, it is possible to run the cables externally by using the
conduit holes on the base of the wall mount.

External links may include paid for promotion

Availability: In Stock
Supplier: Ebuyer
SKU: 789935

Description Reviews / Comments Add New

Product Description

Roomy compartment for protection & connectivity AXIS T91G61 Wall Mount is specially designed to accommodate & safely protect against water ingress inside the mount, such as midspans & media converters. The pre-mounted Ethernet cable with IP66 RJ45 connector (with gasket) helps quickly & easily connecting power & data to most of Axis PTZ network cameras. Beautiful & yet strong Thanks to its impact-resistant & outdoor proven material, AXIS T91G61 Wall Mount suits all environments, both indoors & outdoors. AXIS T91G61 has the same hole pattern as the standard Axis PTZ wall mount & for retrofit, a pattern that matches Pelcos PTZ camera mount to enable an easy switch
- no additional drilling is required. Moreover, it is possible to run the cables externally by using the conduit holes on the base of the wall mount.

Reviews/Comments

Add New

Supplier Information

Ebuyer

Ebuyer.com is an uber cool website for those looking for latest electronic gadgets. With host of freebies and discounted prices across a range of electronic devices right from computers to household appliances, Ebuyer has the distinction of being one of the prominent online electronic gadget retailers in UK. The site showcases over 19,000 quality products from reputed brands such as Apple, Sony, HP and Acer. Computing devices on offer include desktops, tablets, laptops and smart phones, hard drives, flash memory, memory, processors, graphics cards from AMD and NVIDIA, motherboards and other computer components, peripherals, software, audio visual and gaming devices. This site also has a comprehensive collection of household appliances for the homemakers.

More From Contributor

AXIS T91G61 Wall Mount

Product Description

Reviews/Comments

Add New

Intelligent Comparison

Price History

Vouchers

Facebook

Jargon Buster

Supplier Information

Community Generated Product Tags

Contact Us

Information

My Account