United Kingdom
France
Germany
Netherlands
Sweden
USA
Italy
Spain
More From Contributor
Kingston 4GB (2 X 2GB) DDR3 1600MHz HyperX CL9 XMP
Kingstons KHX1600C9D3K2/4GX is a kit of two 256M x 64-bit 2GB (2048MB) DDR3-1600MHz CL9 SDRAM (Synchronous DRAM) memory modules, based on sixteen 128M x 8-bit DDR3 FBGA components per module. Each module kit supports Intel XMP (Extreme Memory Profiles). Total kit capacity is 4GB. Each module kit has been tested to run at DDR3-1600MHz at a low latency timing of 9-9-9-27 at 1.65V. The SPDs are programmed to JEDEC standard latency DDR3-1333MHz timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires +1.5V. The JEDEC standard electrical and mechanical specifications are as follows: **Features** - JEDEC standard 1.5V ± 0.075V Power Supply - VDDQ = 1.5V ± 0.075V - 667MHz fCK for 1333Mb/sec/pin - 8 independent internal bank - Programmable CAS Latency: 5, 6,
7, 8, 9, 10 - Posted CAS - Programmable Additive Latency: 0, CL - 2, or CL - 1 clock - Programmable CAS Write Latency(CWL) = 7(DDR3-1333) - 8-bit pre-fetch - Burst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] - Bi-directional Differential Data Strobe - Internal(self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm ± 1%) - On Die Termination using ODT pin - Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE. 95°C - Asynchronous Reset - PCB: Height 1.180" (30.00mm), double sided component
7, 8, 9, 10 - Posted CAS - Programmable Additive Latency: 0, CL - 2, or CL - 1 clock - Programmable CAS Write Latency(CWL) = 7(DDR3-1333) - 8-bit pre-fetch - Burst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] - Bi-directional Differential Data Strobe - Internal(self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm ± 1%) - On Die Termination using ODT pin - Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE. 95°C - Asynchronous Reset - PCB: Height 1.180" (30.00mm), double sided component
Product Description
Reviews/Comments
Add New
Vouchers
No voucher codes found.
Do you know a voucher code for this product or supplier? Add it to Insights for others to use.
Do you know a voucher code for this product or supplier? Add it to Insights for others to use.
Denmark