The Air Plus Xtreme G DWL-2100AP is an enhanced high-performance 802.11g wireless Access Point for use indoors. This device supports wireless networking speeds of up to 108 Mbps (Turbo mode) on the popular 2.4 G Hz public frequency, while providing seamless interoperability with existing 802.11b wireless equipment. The DWL-2100AP can be configured to operate in any one of the 5 modes: (1) as a wireless access point, (2) a point-to-point bridge with another access point, (3) a point-to-multi-point wireless bridge, (4) a wireless client or (5) a wireless repeater. With these built-in functions, the DWL-2100AP gives you the flexibility to configure the device to meet your environments requirements. Enhanced security is provided with Wi-Fi Protected Access to authorize & identify users based on a secret key that changes automatically at a regular interval. Used in conjunction with a RADIUS server, WPA employs TKIP (Temporal Key Integrity Protocol) to change the temporal key every 10, 000 packets. This insures much greater security than the standard WEP security, which requires the keys to be changed manually. The DWL-2100AP supports 802.1x authentication for protection against network intrusion. Used in conjunction with a RADIUS server, this function provides a means to verify the identity of the client before an access to the network is granted. ...

The DWL-2600AP unified N single-band Po E access point is a best-in-class indoor access point designed specifically for business-class environments. With high data transmission speeds & access point load balancing, the DWL-2600AP offers high-quality & reliable wireless service. Versatile & powerful, the DWL-2600AP can be flexibly deployed as a standalone wireless access point or as a managed access point controlled by a D-Link unified wireless switch or wireless controller. Businesses can start with standalone mode deployment, & then migrate to a centrally managed system anytime later. ...

The DWL-P50 Power over Ethernet adapter is a single-port splitter that provides DC power for a non-Po E-equipped device, such as a surveillance camera or a wireless access point. It is designed to operate with LAN switches & other equipment that support industry-standard 802.3af Power over Ethernet (Po E) to deliver operation power to the networked device, allowing you to install the device at places such as on a rooftop or near a ceiling, where power is not easily accessible. The DWL-P50 supports both 5VDC & 12VDC power & can be flexibly deployed with network devices with different power voltage requirements. The DWL-P50 is useful for installation at a factory or TM Wi-Fi hot spot. This compact adapter means that you can install your surveillance cameras & wireless LAN devices on a building rooftop, on or near a ceiling for maximum coverage. Your cameras or wireless access points can be placed up to 100 meters away from a power source. It is at these places that wall AC outlets are inaccessible & providing power to these locations is difficult & expensive. The DWL-P50 is also handy for installation at offices with Internet telephones connected to a Po E Ethernet switch. It eliminates the need to individually power each IP phone. By transmitting remote power through the standard network cabling, the DWL-P50 does away with the need for an AC outlet at each device location. Only a single Ethernet cable is run to each device instead of separate power & data cables. On a standard 4-wire UTP Category 5 cable, only two pairs (pins 1, 2, 3 & 6) are used for Ethernet data transfer. At one end, your Po E Ethernet switch inserts DC voltage into the unused wires, taking advantage of the unused pair of the network cable wires. At the other end, the DWL-P50 taps the DC power from the Ethernet cable for use by the non-Po E device. Consequently, a single Category 5 cable can now carry both Ethernet data & DC power. The idea is to supply the remote end with power and ...

The DWL-P50 Power over Ethernet adapter is a single-port splitter that provides DC power for a non-Po E-equipped device, such as a surveillance camera or a wireless access point. It is designed to operate with LAN switches & other equipment that support industry-standard 802.3af Power over Ethernet (Po E) to deliver operation power to the networked device, allowing you to install the device at places such as on a rooftop or near a ceiling, where power is not easily accessible. The DWL-P50 supports both 5VDC & 12VDC power & can be flexibly deployed with network devices with different power voltage requirements. The DWL-P50 is useful for installation at a factory or TM Wi-Fi hot spot. This compact adapter means that you can install your surveillance cameras & wireless LAN devices on a building rooftop, on or near a ceiling for maximum coverage. Your cameras or wireless access points can be placed up to 100 meters away from a power source. It is at these places that wall AC outlets are inaccessible & providing power to these locations is difficult & expensive. The DWL-P50 is also handy for installation at offices with Internet telephones connected to a Po E Ethernet switch. It eliminates the need to individually power each IP phone. By transmitting remote power through the standard network cabling, the DWL-P50 does away with the need for an AC outlet at each device location. Only a single Ethernet cable is run to each device instead of separate power & data cables. On a standard 4-wire UTP Category 5 cable, only two pairs (pins 1, 2, 3 & 6) are used for Ethernet data transfer. At one end, your Po E Ethernet switch inserts DC voltage into the unused wires, taking advantage of the unused pair of the network cable wires. At the other end, the DWL-P50 taps the DC power from the Ethernet cable for use by the non-Po E device. Consequently, a single Category 5 cable can now carry both Ethernet data & DC power. The idea is to supply the remote end with power and ...

The DWL-P50 Power over Ethernet adapter is a single-port splitter that provides DC power for a non-Po E-equipped device, such as a surveillance camera or a wireless access point. It is designed to operate with LAN switches & other equipment that support industry-standard 802.3af Power over Ethernet (Po E) to deliver operation power to the networked device, allowing you to install the device at places such as on a rooftop or near a ceiling, where power is not easily accessible. The DWL-P50 supports both 5VDC & 12VDC power & can be flexibly deployed with network devices with different power voltage requirements. The DWL-P50 is useful for installation at a factory or TM Wi-Fi hot spot. This compact adapter means that you can install your surveillance cameras & wireless LAN devices on a building rooftop, on or near a ceiling for maximum coverage. Your cameras or wireless access points can be placed up to 100 meters away from a power source. It is at these places that wall AC outlets are inaccessible & providing power to these locations is difficult & expensive. The DWL-P50 is also handy for installation at offices with Internet telephones connected to a Po E Ethernet switch. It eliminates the need to individually power each IP phone. By transmitting remote power through the standard network cabling, the DWL-P50 does away with the need for an AC outlet at each device location. Only a single Ethernet cable is run to each device instead of separate power & data cables. On a standard 4-wire UTP Category 5 cable, only two pairs (pins 1, 2, 3 & 6) are used for Ethernet data transfer. At one end, your Po E Ethernet switch inserts DC voltage into the unused wires, taking advantage of the unused pair of the network cable wires. At the other end, the DWL-P50 taps the DC power from the Ethernet cable for use by the non-Po E device. Consequently, a single Category 5 cable can now carry both Ethernet data & DC power. The idea is to supply the remote end with power and ...

The DWR-510 Mini 3G 7.2 Mbps USB (Universal Serial Bus) Router means that you can connect your notebook to your mobile broadband service from wherever you are, & share your 3G Internet connection wirelessly, providing a fast & secure Wireless N 150 network for several users at the same time. While connected, you can transfer data, stream media, & send SMS messages. The DWR-510 is completely unlocked & works with data SIM cards from any operator. This Mini USB (Universal Serial Bus) Router could not be simpler to install; it comes with Windows & Mac OS drivers built-in, which will install automatically when the adapter is first inserted in a USB (Universal Serial Bus) port The D-Link DWR-510 is small enough to fit in your pocket: no batteries, cables or antennas needed. The retractable USB (Universal Serial Bus) port can be conveniently hidden away when not in use, making this 3G router truly portable. The DWR-510 built-in memory

Includes:: a Phonebook & SMS Manager. With Phonebook, users can create & edit contacts, create groups, & save the contact list onto the computer. SMS Manager allows users to send, reply & forward SMS messages. Both applications can interact with each other, for example you can save the SMS senders number as a contact on the Phonebook.

...

D-Link's DWR-720 Mobile Wi-Fi Hotspot 21 Mbps uses your mobile 3G Internet connection to give you a simple & fast Wi-Fi network anywhere you need one. Get all your mobile devices connected to the Internet or share a 3G Internet connection with family, friends or colleagues when you are out & about. ...

The Portable HSPA+ 21 Mbps Router (DWR-730) means that you can connect your notebook, tablet & smartphone to the Internet from anywhere there is a 3G connection & share this connection with other users wirelessly. This router is ideal for people that need a portable solution, for example remote workers or people that are moving house & need a temporary Internet connection. You can use this router to share your 3G connection wirelessly. The router will use an available 3G connection to provide a fast & secure Wireless N 150 network for several users at the same time. The device is small enough to fit in your pocket: the rechargeable Li-ion battery means that you can take it with you anywhere & surf the Internet, & if you need to recharge it, you can do it easily with any USB (Universal Serial Bus) wall or car charger. The DWR-730 supports the latest High Speed Packet Access Plus (HSPA+) technology, which offers data rates of up to 21.6 Mbps (5.76 Mbps upload) & helps to reduce latency. This router is also backwards compatible with mobile networks implementing HSUPA & HSPDA technologies. It may be small but it can keep your wireless connection as secure as if you were connected through your home network. Its built-in firewall prevents potential attacks & hacking attempts from the Internet, & with WPA2 encryption, you can be sure that you are sharing your 3G connection only with the users you want to. ...

The Portable HSPA+ 21 Mbps Router (DWR-730) means that you can connect your notebook, tablet & smartphone to the Internet from anywhere there is a 3G connection & share this connection with other users wirelessly. This router is ideal for people that need a portable solution, for example remote workers or people that are moving house & need a temporary Internet connection. You can use this router to share your 3G connection wirelessly. The router will use an available 3G connection to provide a fast & secure Wireless N 150 network for several users at the same time. The device is small enough to fit in your pocket: the rechargeable Li-ion battery means that you can take it with you anywhere & surf the Internet, & if you need to recharge it, you can do it easily with any USB (Universal Serial Bus) wall or car charger. The DWR-730 supports the latest High Speed Packet Access Plus (HSPA+) technology, which offers data rates of up to 21.6 Mbps (5.76 Mbps upload) & helps to reduce latency. This router is also backwards compatible with mobile networks implementing HSUPA & HSPDA technologies. It may be small but it can keep your wireless connection as secure as if you were connected through your home network. Its built-in firewall prevents potential attacks & hacking attempts from the Internet, & with WPA2 encryption, you can be sure that you are sharing your 3G connection only with the users you want to. ...

D-Link's DWR-830 Mobile Wi-Fi Hotspot 42 Mbps uses your 3G DC-HSPA+ Internet connection to give you a simple & fast Wi-Fi network anywhere you need one. Instead of being confined to one Internet-connected device through a USB (Universal Serial Bus) dongle, the DWR-830 means that you can create & share Wi-Fi hotspots anywhere you have a 3G signal. The compact size means you can conveniently take it with you & share your connection anywhere; use it in a cafe to send e-mails while your friend reads the news, or have your laptop, phone, & tablet all connected to the Internet at the same time using just one mobile Internet service. Simply insert your data-enabled USIM card, & this handy device will allow you to share a high speed 3G DC-HSPA+ mobile internet with download speeds of up to 42 Mbps. The DWR-830's small size means you can easily slip it into your pocket or bag & take it with you wherever you go. For when you are on the road, the rechargeable 2380 m Ah Li-on battery means that you can stay connected for longer between charges, & Universal Plug & Play (UPn P) means there's no complicated software to install. Getting online with the DWR-830 Mobile Wi-Fi Hotspot 42 Mbps is quick, easy, & convenient. The DWR-830 Mobile Wi-Fi Hotspot 42 Mbps is easy-to-use &

Includes:: a host of security features. The built-in firewall keeps connected computers & other devices safe from Internet intrusions, while WPA security encryption prevents unauthorized users from connecting to your network. Wi-Fi Protected Setup (WPS) helps you to create a secure wireless network, & add new devices with just the touch of a button, getting you securely connected in no time.

...