
After the overwhelming success of the Liquid Pro the new Coollaboratory Liquid Ultra was developed Of course the Liquid Ultra is also made from 100 metal but it has an absolute new usability & offers an outstanding performance Due to the paste-like texture the application is now very easy The Coollaboratory Liquid Ultra was optimized for highest performance & optimal usability The thermal compound consists to 100 of metal but can be applied very easy with a commercial brush The processor (Heatspreader) should be cleaned thoroughly before apply the Liquid Ultra in order to eliminate dirt old thermal compound or fat Depending on the size of the Heatspreader three to four division lines of Liquid Ultra should be applied centrically on the Heatspreader Then the Liquid Ultra should be disposed slowly & without pressure on the Heatspreader The less pressure is used when elapsing the easier the Liquid Ultra can be applied The Liquid Ultra has a pasty form whereby the application goes very fast Please pay attention to coat also the edges of the Heatspreaders Therefore always use the same brush side It is usually not necessary to apply more Liquid Ultra again for a commercial processor The application is managed within 30-60 seconds on average In the following the application is represented in a short photo distance