Drummond MTL10 & MTL20 Test Lamps
- Martindale DRUMTL20, The Drummond MTL20 test lamp gives safe voltage indication from 50 to 500V AC / DC. In addition to the MTL10, the MTL20 incorporates two test buttons, one on the body of the unit & one on the probe. Simultaneous depression of both buttons enables the unit to draw a high current, allowing the user to differentiate between phantom voltages & hazardous persistent voltages. The robust design meets the recommendations of the Health & Safety Executive in their guidance notes on the electrician's test lamp (GS38) as well as complying with BS EN 61243-3 & BS EN 61010, CAT III 1000V & CAT IV 600V.A unique feature of this Drummond test lamp is the four distinctive bands of illumination, with a 360° viewing angle, providing indication of voltages above 50, 100, 200 & 400 volts, even in bright sunlight. This allows for accurate identification of potentially lethal voltages at 50V & enables the user to distinguish between 110V, 230V & phase-to-phase voltages in a 3-phase system. Both the lamp housing & the probe have a finger shield & insulated probe tip with only 4mm of exposed metal. A two-layer double insulated cable with white inner insulation gives a clear warning of abrasion that might compromise the user's safety, & is resistant to heat & oil. To enable use in most circumstances, a right-angled probe tip is supplied in addition to the two straight tips. For maximum ease of use the right-angled probes can be rotated through 90, 180 & 270°. Drummond MTL20 Test Lamp