The most advanced twin stick radio on the market & now available as a 2.4 G Hz system. Far too many features to list here, but here's just a few of the major ones Major
Features:• Full Three Function Set• 10 Model Memory• CAMPac Facility• Servo monitor display• HRS ESC Setup• Assignable Switches/• 5 Point throttle curve• Brake mix• ABS (Anti-Lock Braking)• Throttle Acceleration• Throttle Speed Function• Steering Speed Function• Digital Electronic Trim• Direct Software Access• Sound Port Manufacturer: Ripmax Model / Part No: 3ch Combo 2.4 G Hz N-Tx (R603FS) (P-CB3VCHF/2-4G)
...

This stunning new mid range stick radio from Futaba is a 40 M Hz synthesised set including the new R303FHS synthesised receiver. ...

This is the stunning new mid range stick set from Futaba. The 40 M Hz `standard' set comes complete with synthesised TX & the ...

The stunning new 3PKBS system is available in both 40 M Hz & 2.4 G Hz versions, & is possibly the leading steerwheel set available ...

System Features LCD Contrast adjustment LCD backlight on/off function Servo monitor display HRS ESC Setup Throttle mode Assignable switches/functions Throttle servo neutral adjustment 5 Point throttle curve (forward) 349.99 Full three function set 10 Model Memory (Standard)CAMPac Facility 110 x 64 LCD w/backlighting High Response System (H.R.S.) Two function selection modes Brake mix ABS (Anti-lock Braking System) Throttle Acceleration function Throttle Speed function Start function Steering Speed function Switchable 7 colour LED pilot light Digital Electronic Trim with sub trim Function select dial function Function select switch function Display switch Adjustable throttle stick travel Adjustable stick angle Adjustable stick tension Direct software access (key functions) Plug in RF module (easy Xtal access)PPM/PCM/HRS switchable Sound port (for optional alarm earpiece) Exponential DSC with optional cord Servo reverse on all channels Dual rates 2nd Dual rate – Steering Idle up Throttle ATL (Adj Travel Limiter) End Point Adjustment Engine cut function Timer (Up, Down, Lap functions) Lap Navigate timer Lap List Programmable mixing – two circuits Tilt mixing – marine function Fail safe function (HRS/PCM only) Model Name Rotary knob 3rd channel Level select Buzzer sound tone adjustment System Features Manufacturer: Ripmax Model / Part No: Futaba 3 Ch Combo HRS FM40 N-Tx (R203H ) (P-CB3VCHF) ...

Futaba 3ch Rx 2.4 G Hz FHSS (P-R203GF/2-4G) Supplied as standard with the new 3PRKA radio system, the R203GF receiver utilises Futaba’s new S-FHSS transmission system for ultimate reliability & interference rejection qualities. Specification: Weight: 14g Channels: 3 Dimensions: 39 x 26 x 10mm ...

The transmitter's shape is ergonomically designed to slip into the hand & makes for easy of operation. The main stick has an offset angle for more accurate control & the throttle or flap rotary slide control, positioned next to the thumb for ease of location, follows the thumb's true line of movement. All in all a transmitter for the beginner to relax & enjoy flying with. Channels 1 & 2 can be mixed for Elevon or V-tail operation & there is servo reverse on on channels 1 & 2. Channel 3's direction is formatted to be used with most modern electric flight speed controllers. System
Features:• Single dual axis stick (aileron or rudder & elevator)• Rotary slide throttle or flap control• Function mixing for elevon / V-tail operation• Servo Reverse on channels 1 & 2• Battery level LED indicators• Micro 4 channel receiver• Ergonomic design for ease of operation Manufacturer: Ripmax Model / Part No: (P-FP3FRF) 3ch S3003x 2 FM35 (D) SS R114F
...

Specification" New Driver", " Race-Ready", " Expert" & " Big Car" menus that add functions based on driving skill level & experience Throttle Mode Select, for selecting acceleration/brake servo neutral points between 70/30 for nitro or 50/50 for electrics Redesigned keypad with large center jog button Vibrating alert system" Direct Select" single-button access to eight pre-assigned functions Navigation Lap Timer that sounds when target lap time is exceeded Servo Display Screen shows set-ups/mixes for individual servos (Expert Menu) Throttle programming options, including 5-point curve, expo & VTR Features Ergonomic design for balance, feel, weight & adjustability 40-model memory 10-character model naming 4th channel for adjusting brake bias 2048 resolution for the ultimate in precision control 2 programmable mixes Assignable buttons & dials Digital trims & dials Advanced Positioning Adapter (APA) Adjustable trigger location Backlit 128 x 64 white LCD screen with adjustable contrast Subtrims, servo reversing & EPA on all channels Throttle Variable Trace Rate (VTR) Fail-safe & battery fail-safe (voltage selectable) Direct Servo Control (DSC) Exponential & adjustable servo speed (Steering/ Throttle) Up/ Down, lap & systems timers 100-lap memory Electronic & mechanical ATL (Adjustable Throttle-Low side only) Traction control/ Acceleration rate ABS braking system Boat programming Idle-up Tx Ni MH & Futaba charger Manufacturer: Ripmax Model / Part No: Futaba 4ch Combo 2.4 G Hz (N-Tx) R604FS (P-CB4PK/2-4G) ...

The new 35 M Hz FM Skysport 4 When you're buying your first radio system, you need a simple & easy-to-use transmitter that will take you through the early stages of learning to fly. With the launch of Futaba's new Skysport 4, you can now buy a Futaba four channel system complete with three servos & the all-important trainer function. With Futaba's trainer function you simply link two transmitters together using a dedicated trainer lead & the instructor can pass control of the model to the student during the flight. More importantly, if the student gets into trouble, the instructor simply releases the trainer switch on his transmitter & takes over. There's nothing simpler or safer. And with the Skysport 4, you also get the benefit of servo reverse on all four channels & a built in charging socket as standard. Mode 2 system, supplied complete with 3 x S3003 servos & 35 M Hz R136F receiver. System Features• Built-in trainer facility• Four channel servo reverse• Supplied complete with 3 x S3003 servos• Nicad batteries for both transmitter & receiver• Supplied complete with charging socket & charger Manufacturer: Ripmax Model / Part No: Futaba 4ch S3003x 3 FM35 (N) M2 R136F (P-FP4YFN/L) ...

Never before has there been an entry level 4 channel computer set with the features of the new 4EX from Futaba. Ideal for anyone taking up scale boats where additional functions or computer mixing are required. The new 4EX has all the functions required for the ultimate in easy setup & operation -without overloading the novice. The transmitter has a built-in charging socket & the set is supplied complete with rechargeable batteries & mains input charger, as well as an R136F full range six channel receiver. With the included trainer facility, the 4EX transmitter can be used as either the 'master' or 'slave' transmitter if required & with its mixing functions, the set is capable of controlling more sophisticated models. As supplied, the transmitter is mode 2 (throttle left), however it is quick & easy to convert to other modesas required. System
Features:• Four model memory• Servo reversing• End point adjustment• Trim memory• Exponential• V-Tail mixing• Elevon mixing• Trainer switch• Multi Mode• Model select/data reset Manufacturer: Ripmax Model / Part No: Futaba 4ch S3003x 3 FM40 (N) MM R136F (P-FP4EXN/40L)
...