Charges 1-4 pieces of AAA & AA batteries Independent charge channel for each battery Negative delta V detection switches off charger immediately the batteries are fully charged Timer control Trickle charge function keeps batteries topped up when fully charged Overcharge short circuit & reverse polarity protection Faulty battery detection Low battery leakage current Pulse charging function LEDs indicate charging status of each individual battery Worldwide voltage range 100V-240V subject to use with a suitable travel adaptor 2-3 hours average charge time ...

Vo IP Voice u Connect With u Connect you can use your regular phone to make Vo IP calls over the Internet Connect your phone to the Internet via your PC amp your regular landline at the same time Plugs directly into the USB (Universal Serial Bus) port of your laptop PC Works with all household phones including cordless phones Very straightforward to setup ...

Listen to your music from up to 80 metres away The signal is emitted through walls so you can listen to your music outside Benefits from 3 transmission channels enabling a constant reception without interference Rechargeable battery pack for approx 8 hours continuous use Suitable for use with your T.V Hifi PC or with your games console ...

Professional UHF wireless system for audio Compander circuit with an integrated limiter guarantees high quality transmission Suitable for applications where cables are not desired or not possible Maximum range of 100m open field Battery life of over 10 hours dependant on the type of battery used Each system consists of one transmitter & two receivers including 40cm XLRjack cables Also

Includes:: a 20cm Velcro tape you can use to attach the receivers Fixed frequency 863-865 MHz Transmitter Frequency range 580 MHz
- 870 MHz RF output power 10 m W Squrious rejection 50 d Bc Peak deviationplusmn 55 KHz Frequency response 50
- 20000 Hz Signal to noise ratio 100 d B ATHD 1 Input voltage range 10 d BV max Power supply 8-12 V DC 400m A Dimensions W x H x D212 x 160 x 44 mm Weight 860 g Receiver Frequency range 580 MHz
- 870 MHz Sensitivity -2 d Bm for d B SN ratio Peak deviationplusmn 55 KHz Frequency response 50
- 20000 Hz Signal to noise ratio 100 d B ATHD 1 Dynamic range 95 d B Audio connector 3.5mm jack socket Audio input level Balanced 3 d Bu max Power supply 2 x 1.5V AA battery Operating time 8 hours Dimensions W x H x D85 x 65 x 23 mm Weight 90 g





...

- Tie-clip belt pack radio microphone system offering superior performance
- Ideal for schools small clubs & pubs in fact anywhere

...

Tie-clip belt pack radio microphone system offering superior performance Ideal for schools small clubs & pubs in fact anywhere a wireless microphone may be required UHF signal gives increased signal quality & range Can be used with electric guitar or bass to make a wire-free environment User-definable 16-channel UHF microphone system run up to 4 mics at the same time 4 full kits would be required Can run alongside other VHF systems due to differing frequencies Low battery consumption Belt pack transmitter is designed for use with a headset lavaliere tie-clip microphone instrument guitar etc. or male XLR cable Auto switching is incorporated to accept either instrument or microphone inputs when used with the adaptor cables Transmitter runs on 2x AA batteries Order code L43ALLow-drain circuitry gives the transmitter extended operating life Onoff switch to save battery power Volume control for microphone on the receiver Balanced XLR unbalanced jack outputs & variable squelch control Can be plugged into an amplifier mixer or any device that accepts mic level audio inputs Adjustable antenna on receiver for enhanced reception & range Up to 75 metre line-of-sight range Receiver runs from DC16V 300m ARF test function Complies with DTI regulations & are totally license-free Operates between 863.00 M Hz to 865.00 M Hz in 16 steps Supplied with beltpack transmitter receiver tie clip mic headset mic belt pack instrument cable connecting leads power supply & full instructions A concealed control plate houses the channel selector switch & gain controls for the instrument & microphone levels. The front panel features power onoff switch with indicator LED RF signal strength indicator signal acquisition indicator RF signal strength indicator channel selector & audio level output. The transmitter pack is also suitable for use with dynamic condenser or phantom-powered microphones.BPlease note B This kit is capable of running only one microphone at a time. If you want to run 4 microphones at the same time then 4 full kits mic & receiver would be required. ...