- Deep cycle capability
- Ideal for solar applications
- Sealed casing for safe spill free performance 8 different batteries


...

- Deep cycle capability
- Ideal for solar applications
- Sealed casing for safe spill free performance 8 different batteries


...

- Deep cycle capability
- Ideal for solar applications
- Sealed casing for safe spill free performance 8 different batteries


...

- Suitable for charging batteries up to 9 Ah capacity
- Automatically switches to trickle charge once battery is full
-


...

Lightweight 1.8kg charger can start a flat battery in 5 minutes Microprocessor-controlled 3-stage charging cycle automatically reconditions & maintains batteries Up to 15A charge rate Digital display shows charge rate & current battery voltage Suitable for 12V lead acid gel & AGM batteries ...

Helps you to control soil humidity in gardens fields & grassed areas Monitors soil humidity in deeper layers Can be used to switch onoff a spray-irrigation system when soil becomes too dry Sensitivity can be adjusted to low or high soil humidity Quick & easy installation Can be combined with a timer for watering the garden on special days or automatically when dry The"must have for people who care about their gardens This sensor can be used to switch on your garden irrigation pump or the magnetic valve when the soil is dry & switch it off when there is enough humidity in the soil. The measuring head has to be buried into the ground at the depth where it shall measure & is connected to the main sensor unit via a 2m cable. The sensor cable may be extended up to 20m with normal 2-pole cable. The device is operated by means of a commercial plug power supply Regulated 12V at gt 130 m A with standard 3.5mm plug
- Order Code MG81C. The main module should be mounted in a weatherproof location. If required the garden can be irrigated at certain times of the day or weekdays only by using a suitable mains timer. The soil humidity sensor starts to operate when it receives current from the power supply in the following sequence 1 The soil humidity is measured after switching on the operating voltage.2 The connected pump is switched on for 18...30 minutes if the soil is too dry.3 If the soil is humid enough the device switches to" Pause for about 18...30 minutes & makes a new measurement after that. This sequence continues in an infinite loop until the operating voltage is switched off. Specifications Switching contact 1 x 3A max screw terminal connections Sensor housing dimensions 30mm diameter x 64mm length Galvanised pins dimensions 4mm diameter x 40mm length Control module dimensions 70 x 50 x 28mm without lugs
...

- 12 volt 10A illuminated round rocker switch to fit a 20mm cut out
- SP on off available in red or green illumination with

...

- 12 volt 10A illuminated round rocker switch to fit a 20mm cut out
- SP on off available in red or green illumination with

...