Stylish contemporary design complements any garden Automatically switches on at dusk & off at dawn 24 hour charge provides up to 8 hours of light Easy installation
- requires no wiring & no electricity costs Super bright white LEDs Height 40cm including ground spike diameter 12cm
...

- ideal to be used under stair carpet
- Four conatct mat that is activated when stepped upon
-

Dimensions




...

Ceramic based 2mm diameter LEDs ideal for pin-point indicators where space is at a premium. Available in red & green. A red spot on the package denotes the anode.

Specification IF20m A Red Green Luminous intensity 1.5mcd 1.5mcd Peak wavelength 700nm 565nm Max forward voltage 2.8V2.8 V Reverse voltage 5V5 V Max reverse current 100micro A100micro A

...

Ceramic based 2mm diameter LEDs ideal for pin-point indicators where space is at a premium. Available in red & green. A red spot on the package denotes the anode.

Specification IF20m A Red Green Luminous intensity 1.5mcd 1.5mcd Peak wavelength 700nm 565nm Max forward voltage 2.8V2.8 V Reverse voltage 5V5 V Max reverse current 100micro A100micro A

...

Standard BT type 4-way & 6-way Line Plugs using Insulation Piercing Contacts IPC with strain relief. To fit the flat line cord shown in the Cables Section to an IPC plug simply provide a clean cut across the end & strip off 11 to 12mm of the outer sheath. Allow the wires to separate from one another by Approx. 1mm then push & tease them gently into the plug which has locating guides built in for each conductor. Once fully home the coloured wires can be seen through the slot behind the contacts use heavy duty pliers or a small vice to press all the gold coloured contacts flush with the plug body push down the small strain relief members immediately behind the contacts then force down the cable clamp at rear. ...

Standard BT type 4-way & 6-way Line Plugs using Insulation Piercing Contacts IPC with strain relief. To fit the flat line cord shown in the Cables Section to an IPC plug simply provide a clean cut across the end & strip off 11 to 12mm of the outer sheath. Allow the wires to separate from one another by Approx. 1mm then push & tease them gently into the plug which has locating guides built in for each conductor. Once fully home the coloured wires can be seen through the slot behind the contacts use heavy duty pliers or a small vice to press all the gold coloured contacts flush with the plug body push down the small strain relief members immediately behind the contacts then force down the cable clamp at rear. ...

- A range of standard bipolar power NPN transistors in TO style cases A range of standard bipolar power NPN transistors in TO
...