PCB Etching Powder 100g 0.5l
- Excellent stability
- 5 to 10 minutes etching time
- Makes 0.5l of solution This sodium persulphate based etch powder has been specifically developed for etching copper laminate used in the electronics industry. The product exhibits excellent stability in use leaving surfaces clean even & free of staining.100g will make 0.5 litres of etch solution.0.5 litres of water is heated to between 40 to 50deg C & the powder is slowly stirred into the water. The solution should last between 4 to 8 weeks but is dependent upon the volume of copper in solution. N.B To prevent premature breakdown of the solution do not operate in excess of 50deg C. Supplied in 100g sachets.