The Crossfire will compliment any collision repair pulling system for fast, accurate under & upper vehicle body alignment. Use or as a comparison tool, checking length, width & height on the damaged side with the undamaged side of the vehicle. Or use with our P2P (point to point) vehicle measuring software with full length, width & height data. No more wasted time taking panels on & off after a pull to check the fit. Realign door pillars, hinges, screen apertures, roof etc., to ensure doors, windows, lamps & panels fit correctly, avoiding uneven panel gaps, poorly fitting locks, leaks & problems with wind noise. Check strut tops, inner wing & front end panel alignment, suspension mounting points & wheel alignment, on or off the jig. Use as an assessment tool before the repair to quickly & positively identify structural damage. ...

This clever little item makes bodywork sanding applications easy. It can be formed & fixed to any desired shape, to suit the contours of modern automotive bodywork. For rough & fine finishing, this is ideal to be used in hard to reach areas. ...

For a range of panel beating & bodywork repair applications. ...

A large curved sanding file, made to be used with the Power-Tec 390mm sanding block. Ideal for quick & effective sanding of large contoured areas. ...

Used extensively in car body restoration work on curved panels. Creates a 20mm deep step or flange onto a curved panel for flush lap weld joints. ...

For use in the automotive repair & painting industry & for estimators & insurers, this handy pocket sized gadget is used to measure the thickness of paint coatings on steel bodywork panels. Measuring up to 0.10 mil or micron, this tool can be used on handed & doesnt require calibration, meaning it can be used continually across any length of panel, providing a read out for every section it covers. ...

For removing vehicle door hinge pins, allowing for quick & easy removal of doors in need of repair. This easy to use tool even removes stubborn pins &

Includes:: a pin puller to remove loosened pins.

...

Make potentially tricky door removal & installation jobs easier by using this easy to use door removal/install st&. Manufactured to allow users to single handedly work with vehicle doors, this durable, heavy duty stand is mounted on castors for great portability & is manufactured to align the door to the hinges on the vehicle & hold it in place while the holding screws are put in or removed. Ideal for professionals or DIYers. ...

Simple to use & suitable for use on a wide range of vehicles, this extending rear hatch support is used to support the rear hatch & hold it at a suitable angle/height while it is being painted or repaired. Featuring able to extend from 720mm to 1840mm, this simple, yet useful device can be used on hatchbacks, estates, saloons & even some SUVs. ...

A handy & easy to use tool, designed to create 13mm deep, 20 gauge steps or flange in sheet metal, or 7mm holes if required. Ideal for panel replacement, patching & for plug welding preparation. ...