Ideal when welding patch repairs in floors, wings, door skins, or when assembling fabricated panels on reskinning projects. The intergrips will clamp flat, curved or even pressed ribbed panels & are designed to leave only a small gap which will allow full penetration of the weld. Once the two sections are tack welded together, the wing nut is slackened, the toggle bar removed & the clamp lifted from the job prior to the final welding. ...

Perfect for repairing small to medium-sized damage on plastic parts, the Power-TEC Plastic Welding Kit is suited to both general garage & workshop use, where a quick & robust repair is necessary. Cordless with piezo ignition, the butane-gas powered welder is small, convenient, & ideal for welding thin plastic parts using the highly concentrated heat output. Kit
Includes:: Gas soldering iron 9mm/12mm welding tips Screwdriver Cleaning rod Wire brush 3 x steel mesh 10cm x 6cm 6 x PP welding rods 6 x PS welding rods 6 x PE welding rods 6 x ABS welding rods
...

The Power-Tec 92443 Rotamate Panel Stand is the ideal addition to any paint shop thanks to the all round design allowing it to hold doors, bonnets, grilles & mirrors. ...

A regulator for compressed air lines. ...

22m of braided wire for glass & trim removal. ...

This Grid Dolly is made from finest top quality forged steel, heat treated under controlled conditions, ground & polished to a high standard. Use this Grid Dolly for shrinking slightly stretched areas. Cross-milling covers the face of this beater. Using this Grid Dolly, small amounts of metal are forced into spaces in the cross-milled face. It may be used on cold aluminium or sheet steel. ...

This Heel dolly is made from finest top quality forged steel, heat treated under controlled conditions, ground & polished to a high standard. ...

Maximise productivity with this new 2k W infrared paint drying unit from Power-TEC — it provides a cost effective method of paint drying & curing can be achieved in just minutes. The use of short wave infrared technology enables paints, primers & body fillers to be cured in typically ten minutes as opposed to 30-40 minutes in an oven. The Power-TEC unit is CE approved, operates from a single phase power supply & has a useful adjustable timer. Fully adjustable height & angle to obtain efficient drying & curing, maximum curing area is 800mm x 800mm. The drying unit runs from a 220V AC supply & is supplied fitted with a 13 Amp, three-pin plug. A convenient & efficient addition to the bodyshop. ...

This Long Reach Spoon is made from finest top quality forged steel, heat treated under controlled conditions, ground & polished to a high standard. ...

This Moulding Spoon is made from finest top quality forged steel, heat treated under controlled conditions, ground & polished to a high standard. ...