Beaver Reg/ Valve O-Rings Euro Type
- Standard
Fits between European type cross flow cylinder valve & A-Clamp regulator
...Apeks Low Pressure Rubber Hoses
All LP hoses & Inflator hoses are manufactured at the Apeks factory.
Lightweight
...Apeks Low Pressure Rubber Hoses
All LP hoses & Inflator hoses are manufactured at the Apeks factory.
Lightweight
...Lumb Brothers Regulator Necklace
Solid one piece Silicone necklace for holding Regulator Mouthpieces. Will not float over
...Lumb Brothers Regulator Necklace
Solid one piece Silicone necklace for holding Regulator Mouthpieces. Will not float over
...Lumb Brothers Regulator Necklace
Solid one piece Silicone necklace for holding Regulator Mouthpieces. Will not float over
...Beaver Octo Ready Octopus Loop
Solid one piece silicone necklace for holding Regulator Mouthpieces. Will not float over
...Beaver Octo Ready Octopus Loop
Solid one piece silicone necklace for holding Regulator Mouthpieces. Will not float over
...Apeks Low Pressure Rubber Hoses
All LP hoses and Inflator hoses are manufactured at the Apeks factory.
Lightweight flexible hoses withstand a burst pressure more than twice that of traditional hoses.
The typical standard hose length
Apeks Low Pressure Rubber Hoses
All LP hoses & Inflator hoses are manufactured at the Apeks factory.
Lightweight flexible hoses withstand a burst pressure more than twice that of traditional hoses.
The typical standard hose length for Primary second stage is 75cm, but pleae note that it might vary from manufacturer to manufacturer & potentially even between sizes.
Most regulators use two different fittings, one for low pressure supplied to the second stage & another for high pressure for contents gauges & transmitters, which prevents the wrong hose being inserted into the wrong port. Generally, low pressure uses a 3/8" threaded hose & high pressure uses a 7/16" hose. However, some manufacturers use other sizes (most commonly a 1/2" port) for the low pressure side.
Features:
Regulator First Stages that use 3/8" UNF Low Pressure Ports
Regulator First Stages that use a 1/2" UNF Low Pressure Ports
Safe Second Stages
These units use a different quick disconnect to the one used on a normal inflator but the hose itself is the same as a regulator hose with the addition of an adapter on the end. There are a couple of different adapters so make sure you get the right one if you need to replace the hose / adapter.