Regulator Low Pressure Hose

Product Description

Apeks Low Pressure Rubber Hoses

All LP hoses & Inflator hoses are manufactured at the Apeks factory.

Lightweight flexible hoses withstand a burst pressure more than twice that of traditional hoses.

The typical standard hose length for Primary second stage is 75cm, but pleae note that it might vary from manufacturer to manufacturer & potentially even between sizes.

Most regulators use two different fittings, one for low pressure supplied to the second stage & another for high pressure for contents gauges & transmitters, which prevents the wrong hose being inserted into the wrong port. Generally, low pressure uses a 3/8" threaded hose & high pressure uses a 7/16" hose. However, some manufacturers use other sizes (most commonly a 1/2" port) for the low pressure side. 

Features:

• Genuine Apeks hoses
• Rubber) & we will send you a costing
• Made in-house at Apeks.  
• See length options & fittings

Regulator First Stages that use 3/8" UNF Low Pressure Ports

• All current Apeks
• All current Aqua Lung
• All Cressi
• All Dive Rite
• All Oceanic
• All Scubapro
• All Seac Sub
• Mares 2S, 12S & 52 first  Stages

Regulator  First Stages that use a 1/2" UNF Low Pressure Ports

• Some older Apeks
• Mares 22 first  Stage

Safe Second Stages

These units use a different quick disconnect to the one used on a normal inflator but the hose itself is the same as a regulator hose with the addition of an adapter on the end.  There are a couple of different adapters so make sure you get the right one if you need to replace the hose / adapter.

• For the Apeks Octo Plus, Sea Quest Air Source (including 1, 2 & Air Source 3 QD), Zeagle Octo-Plus, Aqualung Air Mic, Mares Air Control, Beauchat Venturi, US Divers Air Mic, Oceanic Air XS, Aeris Air Link & compatible BCDs.
• For the Scubapro Air II, Tusa Duo-Air, Sherwood Gemini, Dive Rite Rite Source, H2 Odyssea Inflator plus, Atomic Aquatics SS1 or Zeagle Octo-Z Breathable & compatible BCDs.