More From Contributor

M2R 50R Rear Hydraulic Brake Line\n Front brake line which allows hydraulic brake fluid to be pumped to & from the reservoir & caliper\n Shown as part 45\n Part Number: 4.190.0170 ...

Available

M2R 50R Rear Silencer Muffler\n Rear section of the 50R exhaust. Known as a silencer or muffler.\n 28mm Exhaust Pipe Fitment\n Shown as part 4\n Part Number: 1.085.0101 ...

Available

M2R 50R Rear Silencer Muffler Bracket Frame Spacer\n The bracket is attached to the rear frame with this with a bolt 2 x washer & this frame spacer.\n Shown as part 10\n Part Number: 3.330.0190 ...

Available

M2R 50R Rear Sprocket\n 420 Pitch 43 tooth rear sprocket.\n Standard factory gearing for the 50R.\n Shown as part 11\n Part Number: 2.040.0240 ...

Available

M2R 50R Rear Swing Arm\n Bare swing arm\n Shown as part 2\n Part Number: 3.510.0270\n Entire Length 382mm Internal Length at Pivot axle end 102mm Internal Length at wheel end 182mm Inside Length for wheel fitment 220mm\n Swing arm bolt sleeve

Dimensions Not Included\n Length 139mm\ninner diameter 12mm\n Outer diameter 16mm

...

Available

M2R 50R Rear Swing Arm Chain Slider\n The rubber chain slider is also known as a swing arm protector. Its job is to protector the swing arm from wear from the chain running over it.\n Shown as part 7\n Part Number: 3.350.0030 ...

Available

M2R 50R Rear Swing Arm Spacer\n Internal swing arm bolt spacer\n Shown as part 3\n Part Number: 3.340.0400\nswing arm spacer

...

Available

M2R 50R Throttle Cable\n Genuine factory throttle cable for the 50R dirt bike.\n Shown as part 5\n Part Number: 4.110.0500 ...

Available

M2R 50R Wiring Loom Full engine wiring loom. Also referred to as a wiring harness. Shown as part 10\n Part Number: 5.010.0285 ...

Available

M2R 50R Rear Swing Arm Bolt

M2R 50R Rear Swing Arm Bolt\nThis bolt attaches through the swing arm connecting it to the main frame. Uses nut 5 to secure.\nShown as part 4\nPart Number: 3.130.0200