United Kingdom
France
Germany
Netherlands
Sweden
USA
Italy
Spain
More From Contributor
Glass Polishing Windscreen Kit
Polish away light hairline scratches, scuffs, surface marks, water marks, mineral deposits Ideal solution for DIY repairs Designed to be used with an electric drill recommended of 2000rpm Can be used on any type of glass surface (including toughened glass) Comes with easy to follow step by step instructions KIT CONTAINS 2'' 50mm Velcro Backing Pad (with drill attachment) 2 x 2' 50mm Rayon Felt Polishing Pads 50ml Fine Glass Polishing compound Polishing Cloth Instructions INSTRUCTIONS Step 1 – Cleaning Make sure glass surface is clean, if it’s not clean use water and the microfiber cloth supplied or soft paper towel to thoroughly clean the glass. Ensure that the glass is checked for any exisiting damage. Unless you are working on toughened glass, if the glass has cracks or
chips the repair work may cause the glass to the crack further or break. Step 2 – Backing Pad Assembly Screw in the backing pad spindle to the back of the backing pad, and then attach the backing pad to a drill. Frost recommends work with an ordinary corded electric drill operating at a speed of 1500-2000rpm. Step 3 – Polish Pad Assembly & Compound Attach the velour felt polishing pad to the backing pad, with the back velour side facing the pad and the white side exposed. Add half a teaspoon of glass polishing compound to the middle of the pad. Step 4 – Glass Polishing Stage Hold the pad flat against the glass and start the drill. Keeping the pad flat, move slowly from left to right, up and down. Keep a firm, even pressure as you move the pad over the glass. Continue polishing
until the slurry is dry and add a small amount of water to the pad or glass and repeat this process as many times as necessary until the glass is visually clear and the damage removed. Step 5 – Final Clean and Inspection Wipe the surface clean and inspect carefully. The glass surface should now be crystal clear. If this is not the case, then repeat step 4 and check again. Alternatively, if the scratch has not polished out, it could be because the scratch is too deep for this non-abrasive process.
chips the repair work may cause the glass to the crack further or break. Step 2 – Backing Pad Assembly Screw in the backing pad spindle to the back of the backing pad, and then attach the backing pad to a drill. Frost recommends work with an ordinary corded electric drill operating at a speed of 1500-2000rpm. Step 3 – Polish Pad Assembly & Compound Attach the velour felt polishing pad to the backing pad, with the back velour side facing the pad and the white side exposed. Add half a teaspoon of glass polishing compound to the middle of the pad. Step 4 – Glass Polishing Stage Hold the pad flat against the glass and start the drill. Keeping the pad flat, move slowly from left to right, up and down. Keep a firm, even pressure as you move the pad over the glass. Continue polishing
until the slurry is dry and add a small amount of water to the pad or glass and repeat this process as many times as necessary until the glass is visually clear and the damage removed. Step 5 – Final Clean and Inspection Wipe the surface clean and inspect carefully. The glass surface should now be crystal clear. If this is not the case, then repeat step 4 and check again. Alternatively, if the scratch has not polished out, it could be because the scratch is too deep for this non-abrasive process.
Product Description
Reviews/Comments
Add New
Vouchers
No voucher codes found.
Do you know a voucher code for this product or supplier? Add it to Insights for others to use.
Do you know a voucher code for this product or supplier? Add it to Insights for others to use.
Denmark