Xenta white switched single socket with 2 x USB (Universal Serial Bus) charging ports. perfect for charging iPads, iPhones, tablets, mobiles, cameras & more. Specification: 5 volt 2.4 amp shared USB (Universal Serial Bus) outputs Type A Requires 25mm depth wall box We recommend using a competent person for installation. Only suitable for indoor installations. Before carrying out any electrical work, isolate the mains power supply & refer to the fitting instructions. For safe installation & connection ensure that the earth is connected. Wire/wiring colours are in accordance with the current IET Wiring Regulations. Before use we recommend that a socket test is carried out. This device must be installed by a competent person, in accordance with the current edition of the IET Wiring Regulations (BS7671) & Building Regulations. Please read these instructions carefully before commencing with installation. Failure to install correctly will negate the product warranty. Instructions: Firstly, ensure you isolate the mains power supply & remove the fuse in the fuse box or switch off the circuit breaker in the consumer unit. Following the diagram over-leaf pass the cable through the entry holes & connect to the appropriate terminal. If an Earth loop connection is required, use the additional earth terminal block located in the back box. Re-connect the mains supply when the installation is correctly completed. Before use we recommend that a socket test is carried out. DO NOT MEGGER TEST this will damage the USB (Universal Serial Bus) charging circuit.