1520/1550 Series Power Injector The power injector (AIR-PWRINJ1500-2=) has three LEDs on the front end of the case Monitoring the Power Injector LEDs You can use the AP Power, Fault, & AC Power LEDs to check the power injector status. The LEDs provide the following status information: AP Power LED— Turns solid green after successful discovery; indicates that power injector is supplying power to the access point. Fault LED— Turns solid red when a fault occurs during discovery mode or power-up. Check Ethernet cables & connections before contacting your support organization for assistance. AC Power LED— Turns solid green when power injector is receiving AC power & is ready to provide power to the access point. Image; 1
- Mounting tab 2
- Access point power LED 3
- Fault LED 4
- AC power LED 5
- Ethernet connector (RJ-45) to access point (10/100/1000BASE-T) 6
- Ethernet connector (RJ-45) to switch (10/100/1000BASE-T) Do not use any other power injector or switch for Power over Ethernet with the 1550 Series access points. The 1550 Series is approved for use only with the AIR-PWRINJ1500-2=. You must also specify the country type power cord for the power injector. The AIR-PWRINJ1500-2= is for indoor use only. It has built-in surge protection, but you may also need to install a surge protector at the building entry point. Please check your local electrical regulations.