Cisco Aironet 2.4-GHz access point antennas are compatible with all Cisco RP-TNC-equipped access points. Coupling the appropriate antenna & access point allows for efficient coverage in any facility, as well as better reliability at higher data rates. ...

Cisco single white dipole antenna with an RP-TNC connector antenna provides indoor omni directional coverage & is designed for use in the 2400-2500 MHz frequency b&. It has a 90-foot articulation radius. It can be used with all radios that utilize an RP-TNC antenna connector. ...

Cisco Aironet 3.5-d Bi Articulated Dipole Antenna operates in the 5-GHz frequency band & is designed for use with Cisco Aironet 5-GHz radio products using a reverse-polarity Neil Councilman connector (RP-TNC). The antenna has an articulated base that can be rotated 360 degrees at the connection point & from 0 to 90 degrees at its knuckle with detents at 45 & 90 degrees. Please note: networking components such as switches, routers, UPS & wireless devices require that speeds & standards be consistent throughout the network to gain optimum performance. To avoid compatibility clashes or for advice, please contact us on solutions@ebuyer.com. ...

System Requirements This antenna is designed for use with Cisco Aironet access points that support simultaneous operation in the 2.4 GHz band & the 5 GHz band & that have dual-band antenna ports, labeled as such in orange text. Features The antenna has an articulated base that can be rotated 360 degrees at the connection point & from 0 to 90 degrees at its joint.

Specification Antenna type - Dual-band dipole Operating frequency range
- 2400 to 2500 MHz
- 5150 to 5850 MHz Nominal input impedance - 50 Ohms VSWR - Less than 2:1 Peak Gain @ 2.4. GHz -2 d Bi Peak Gain @ 5 GHz - 4 d Bi Elevation plane 3d B beamwidth @2.4 GHz - 63 degrees Elevation plane 3d B beamwidth @ 5 GHz - 39 degrees Connector type - RP-TNC plug Antenna length - 6.63 in. (168.5 mm) Antenna width - 0.83 in (21 mm) Radome length - 4.88 in. (124 mm) Weight -1.3 oz Operating temperature -20°C to 60°C (-4° to 140°F) Storage temperature -40°C to 85°C (-40°F to 185°F) Environment - Indoor, office



...

The next generation of Cisco Aironet 802.11n access points requires the use of dual-band external antennas to make them fully functioning units. As these access points take greater advantage of the multiple-input multiple-output (MIMO) features supported under the 802.11n standard, the number of radio transceivers per frequency band has increased. Using dual-band antenna ports allows the access point to support these added transceivers while maintaining a reasonably low number of antenna connections. Each dual-band antenna can transmit or receive Wi-Fi signals in both the 2.4-GHz & 5-GHz bands simultaneously. ...

Overvoltage transients can be created through lightning static discharges, switch processes, direct contact with power lines, or through earth currents. The Cisco Aironet AIR-ACC245LA-R Lightning Arrestor limits the amplitude & duration of disturbing interference voltages & improves the overvoltage resistance of in-line equipment, systems, & components. A lightning arrestor installed according to these mounting instructions balances the voltage potential, thus preventing inductive interference to parallel signal lines within the protected system. The Cisco Aironet AIR-ACC245LA-R Lightning Arrestor is designed for use with Cisco Aironet access points & bridges but can be used Cisco Aironet radio device that utilizes an RP-TNC connector. ...

Cisco AIR-ANT5160V-R 6-d Bi omnidirectional antenna is a ruggedized high-performance colinear antenna that operates in the 5-GHz frequency range & is designed for use in large rooms or vaulted areas where extended coverage is needed. The antenna is designed to be used indoors or outdoors & can be mounted on a mast. Please note: networking components such as switches, routers, UPS & wireless devices require that speeds & standards be consistent throughout the network to gain optimum performance. To avoid compatibility clashes or for advice, please contact us on solutions@ebuyer.com. ...

The AIR-ANT2460P-R is a wall mount, indoor/outdoor directional patch antenna. Designed for use with any radio that features an RP-TNC antenna connector. For use in the 2400-2500 MHz frequency b&. The pigtail cable is plenum rated, 36" long. Please note: networking components such as switches, routers, UPS & wireless devices require that speeds & standards be consistent throughout the network to gain optimum performance. To avoid compatibility clashes or for advice, please contact us on solutions@ebuyer.com. ...

The AIR-ANT2485P-R is a wall mount indoor/outdoor antenna with a RP-TNC connector-Designed for use with any radio that features a RP-TNC connector. For use in the 2400-2500 MHz frequency b&. The plenum rated pigtail cable is 36" long. Please note: networking components such as switches, routers, UPS & wireless devices require that speeds & standards be consistent throughout the network to gain optimum performance. To avoid compatibility clashes or for advice, please contact us on solutions@ebuyer.com. ...

Cisco Aironet Power Injector products increase the deployment flexibility of Cisco Aironet wireless access points & bridges by providing an alternative powering option to local power, inline power-capable multiport switches, and multiport power patch panels. The Cisco Aironet Power Injector (AIR-PWRINJ5) increases wireless LAN deployment flexibility of Cisco Aironet Access Points by providing an alternative powering option to local power, inline power-capable multiport switches, & multiport power patch panels. The single-port Cisco Aironet Power Injector provides 802.3af power & data signal, sending both to the Cisco Aironet Access Point. The power injectors provide up to 15.4 W over the unused wire pairs of a Category 5 or better Ethernet cable, supplying enough power for a distance of 328 ft. (100 m) on the Cisco Aironet 1040, 1140, 1260, 2600, & 3500 Series Access Points. While it can also support the Cisco Aironet Series 3600 Access Points when modules are not being used, it is recommended to use the AIR-PWRINJ4= power injector instead for the 3600 series, as it has sufficient power to supply to the AP & any installed modules. Specifications Product Description Cisco Aironet Power Injector
- power injector
- 15.4 Watt Device Type Power injector
- external 802.3af compliant Input Voltage AC 100-240 V Power Capacity 15.4 Watt Output Connector (s) RJ-45

Dimensions (Wx Dx H) 16.5 cm x 6.5 cm x 3.6 cm Designed For Aironet 1602e Controller-based, 1602e Standalone, 1602i Controller-based, 1602i Standalone




...