Solid carbide saw blade 50 mm diameter (10mm bore). 0.5 mm thick fine toothed. Ideal for cutting fibreglass shets, nf metals, duro-plastics & other difficult materials for fast, clean cuts. Teeth are individually set & sharpened. Superior cutting power!. ...

Sands long edges, end sections, radii, mitres & by turning work piece over
- accurate flat surfaces at right angles. Used on
...

The ideal machine for accurate, straight cuts. With a height adjustment & tilting blade. Useable on all wood types, non-ferrous metals, plastics (abs, pertinax, foam rubber) as well as rubber, cork, etc. Even the smallest items may be cut cleanly, obviating subsequent finishing: a table indicates the recommended speeds for various materials substantial construction with load bearing parts of die-cast aluminium. Machined aluminium top measures 295 x 240 mm. mitre slot & fence are provided. An extension wing is housed intregrally & pulled out to increase effective table width to 500 mm. depth of cut is adjustable from 1 to 22 mm. the blade may be tilted through 45°. Drive is effected via a special, quiet motor & optibelt. the blade arbor has ball bearings & is fitted with a tct blade 80 x 1.6 x 10 mm (px-28734) as standard. technical data: 220
- 240 volt motor, 50/60 hz. electronic speed control, with feetback effect for speeds of 4, 400
- 6, 800 rpm. overall

Size: 300 x 262 x 170 mm (without extension wing). weight approx. 5.2 kg. table

Size: 295 x 240 mm. depth of cut: 1
- 22 mm, uses all blades 50
- 85 mm diameter with 10 mm bore.







...

The perfect machine for tool & die making, model building, toy repairs, puzzle sawing, architectural work, antique restoration etc. Absolutely safe: ideal for schools & training centres. Super cutting capacity (wood to 50 mm, plastics 30 mm, non-ferrous metals 10 mm) & yet runs with only a low hum. Problem-free
- even when cutting acrylics, fibreglass, polystyrene foams, rubber, leather & cork. Air blower with adjustable nozzle provides clear visibillity of work piece & cutting line. Machine base of cast iron for vibration-free operation & stability. Sturdy aluminium die-cast table (tilts up to 45° for mitre sawing).twin cast iron saw over-arm with ball bearing direct drive & knob for tensioning blade. Standard commercially available pin blades can be rapidly fitted & stored in the special compartment on the side of the machine. The clamping jaws also clamp plain end blades. Technical data: 220
- 240 volt, variable speed. Stroke length 19 mm. Table 362 x 180 mm (tilts up to 45° for mitre cutting). Max.throat depth 400 mm, max. depth of cut 50 mm (25 mm at 45° table tilt). Weight 20 kg, depth 53 cm, height 30 cm, width 28 cm. Complete with 5 each coarse & fine blades & t allen key..

...