After releasing the pushbutton, the light signal runs quickly round the 10 LEDs in a circle, slows & then stops randomly at one of the LEDs. All LEDs are lit during operation except for the LED currently receiving the signal. The illuminated circuit board looks very decorative. ...

This very small, highly integrated flasher is connected directly to the light emitting diodes. It can simultaneously flash one or several light emitting diodes or flash 2 LEDs or LED groups alternately (alternating flasher). The module is short circuit proof & protected against reverse polarity. Connection option for 1–10 light emitting diodes. Due to its very small, slim design, this flasher is also suitable for sewing into outerwear as well as for use in models & toys. So you can decorate your clothing with flashing, coloured light emitting diodes for fancy dress parties or clubbing. ...

For lead-acid batteries from 6 to 24 V/DC. This battery switch can be used to charge 2 rechargeable batteries separately using a power source such as a car alternator, solar power system, wind turbine, battery charger & so on. For charging currents up to max. 10 A (20 A with cooling). The charging current is distributed so that flat batteries are charged more strongly than almost full ones. Ideal for running TVs, radios & so on from one rechargeable battery in camper vans & keeping a second battery fully charged for ignition. Also useful in holiday homes to prevent the alarm system's rechargeable batteries from running down. ...

This LED with soldered constant current electronics may be connected at any voltage between 4–30 V/DC. The LED shines with almost constant brightness & has a consumption of ca.15 m A. An additional protective resistor is not required. The supplied LED can be exchanged for any other LED. It is also possible to connect several LEDs in series. ...

Power control for resistive loads & motors operated via push button or sensor contact. When the button is pressed, it automatically powers up & down again & remains in the setting when the button is released. If the button is pressed briefly when in the desired setting, the power controller turns off. Press again briefly to turn it back on the last setting. It can be used as a light pulsator with pulses of 5–9 seconds. ...