This code lock can do more than simply open a door. By individually assigning code combinations, you can target activation of two different output relays, so that this system is also well suited for controlling plant & machinery. An unbelievably wide range of different code & user combinations is available. If a code is entered incorrectly 10 times, the keypad can be locked or a quiet alarm triggered. In addition, an integrated sabotage contact reliably protects against unauthorized opening of the case. The 3 integrated LEDs can be switched as required to indicate the system state. ...

The DCS 3000 code lock is perfect for outdoor use. The keyboard is effectively protected against sabotage by a metal front. The sabotage contact operates when the housing is opened to prevent interference with the system. In the event of a power failure the individual code is maintained for up to 48 hours. This may be a combination of between 1 & 12 digits. There is a jumper to set the voltage-free relay output to momentary or latching action. ...

Digital transmission requires long cable types that hold the associated voltage drop as low as possible. Therefore, according to EIA 485-Standard & DMX 512-Specification these CDMX cables are with a conductor cross section of at least 0.22 mm&sup 2 (AWG 24). A double shielding as demanded by PLASA & USITT, is reached by the combination of foil & network screen & gives the CDMX an in addition high tensile strength. This cable reahed at a baud rate of 250 k Hz ensure the required wave resistance between 100 & 120 Ohm, & is therefore uniformly for the transmission of DMX & AES/EBU signals. ...

Digital transmission requires long cable types that hold the associated voltage drop as low as possible. Therefore, according to EIA 485-Standard & DMX 512-Specification these CDMX cables are with a conductor cross section of at least 0.22 mm&sup 2 (AWG 24). A double shielding as demanded by PLASA & USITT, is reached by the combination of foil & network screen & gives the CDMX an in addition high tensile strength. This cable reahed at a baud rate of 250 k Hz ensure the required wave resistance between 100 & 120 Ohm, & is therefore uniformly for the transmission of DMX & AES/EBU signals. ...

The SIRIUS 3UG4 control relays enable optimal protection for machines & plants with fixed installation for protection against surge & undervoltage or for complete network monitoring in case of transportable equipment. Monitoring of motor loads & functioning of electrical consumers also support the control relays 3UG4 for power, Cos phi & active current control. The 3UG4 control relays also supervise non electric values like filling levels & motor speed.
Special

Features:
Can be used in all networks of the world due to varying voltage, permanent display of actual value & type of error in the digital variants, all versions with detachable clamps, small width



...

The SIRIUS 3UG4 control relays enable optimal protection for machines & plants with fixed installation for protection against surge & undervoltage or for complete network monitoring in case of transportable equipment. Monitoring of motor loads & functioning of electrical consumers also support the control relays 3UG4 for power, Cos phi & active current control. The 3UG4 control relays also supervise non electric values like filling levels & motor speed.
Special

Features:
Can be used in all networks of the world due to varying voltage, permanent display of actual value & type of error in the digital variants, all versions with detachable clamps, small width



...

The single-channel digital display with bezel sizes of 48 x 24 mm (di 32) & 96 x 48 mm (di 08) allow you to display readings & the monitor threshold values in industrial applications. The configurable analogue input allows for the direct connection of thermocouples, resistance thermometers, remote resistance sensors, potentiometers or measurement value sensors with a standard signal. The sampling rate for the measurement input is 4 measurements per second. Depending on the model, the device has an easy-to-read 10 mm high (JUMO di 32) or 20mm high (JUMO di 08), 4-digit LED display for showing readings & dialogue management. J Configuration possible using just three buttons. Parameter configuration is designed to be dynamic. Input is automatically accepted after two seconds of inactivity. The degree of protection is IP66 at the front, IP20 at the rear. Electrical connection via a pluggable screw-terminal strip. ...