A fine, colorless spray that reduces glare on reflective surfaces & minimizes "hot spots". ...

Used for highlighting objects. ...

Travel Charger for TWO high-powered USB (Universal Serial Bus) outlets. Charges two USB (Universal Serial Bus) devices simultaneously Charges two iPads simultaneously 3x more powerful than its predecessor 2.1 Amp + 1.0 Amp USB (Universal Serial Bus) output current for tablets, mobile phones & other devices Worldwide interchangeable plugs included (UK, EU, USA + Aus plugs Lightweight & incredibly compact in size
- ideal for travel & business Compatible with iPad, iPhone, iPod, Samsung Galaxy, HTC, Sony Xperia, Nexus & more! Part No. 1000 646.0
...

This reel is adjustable for 3.5cm, 46 mm & 120/220 films. No loader is needed; the film is "walked" into the reel. Using the Duo-Clip enables it to hold two rolls of 120 film. To load 3.5cm film, cut the end square, & trim the corners on the lead end of the film. For 120/220 films, remove the paper backing & fold over the tape to make the film end more rigid. Again, trim the corners on the lead end of the film. Open the Duo-Clip & then push the film into the opening on the outer layer of the reel. Press your right index finger on the film edge protruding through the recessed section of the reel. Turn the right half of the reel forward (clockwise) until it stops to advance the film. Lift your right index finger & repeat the same procedure with the left half of the reel By advancing the film alternately with the right & left halves of the reel, load the full length of the film into the reel. (Remove any cartridges or spools attached to the end of the film.) When loading two 120 rolls into the reel, advance the first to the stop at the center of the reel. Press down the Duo-Clip to prevent the film from moving & then load the second roll, in the same manner as the first, until the trailing edge of the film has gotten just into the outer layer of the reel. The pin on the inside of the reel prevents the inner layers of film from touching each other. ...

Hahnel Duo Pal Extra Charger for Go Pro Hero 4 Batteries Powerful Charging On The Go!! Built-in high capacity 5200 Ah Power Bank charges TWO Hero 4 batteries simultaneously. Quick facts: Charge two batteries in just 2.5 hours Fully compatible with original Hero 4 batteries Charge TWO Hero 4 batteries simultaneously HIGH POWER 5200m Ah internal power bank provides emergency charging power on the go Batteries fully charged in just 2.5 hours Up to 5 hours of recording time Mini USB (Universal Serial Bus) to USB (Universal Serial Bus) cable included Any USB (Universal Serial Bus) Adapter or power source can be used with the Duo Pal Extra? (not included) Also available as a KIT which

Includes:: the hähnel HL-GP401 battery. Connect to the mains power source & the batteries will charge first. Once the batteries are fully charged, the power bank will then start to charge. Also charges smartphones, tablets etc. Recharging made easy: Via mini USB (Universal Serial Bus) Via micro USB (Universal Serial Bus) From the mains 12V Car Plug Computer or any other USB (Universal Serial Bus) output

...

The amazing duopod is a two-in-one mini monopod & tripod kit. Compatible with all KUZO & MUVI Camcorders & all standard cameras & camcorders with a standard tripod thread. The Veho Duo Pod is the perfect combination accessory for the Photo/ Camcorder enthusiast. Its lightweight & compact size makes its suitable to 'pack & go' whatever your adventure, camera or camcorder. Used as a monopod with the MUVI HD actioncam the Duo Pod allows perfect self capture of that all important shred down the slopes. Used as a Tripod it's easy to 'setup & go' for perfect stills, time-lapse or video footage. The Duo Pod has 4 telescopic sections & is so versatile it has over 30 setting combinations & limitless usage scenarios. Key

Features:
- Detachable & extendable monopod with foam grip & multi angle lock & load ballhead perfect for self capture
- 2 times universal tripod mounts for use with all camcorders/cameras up to maximum weight of 500g
- 3 extendable tripod legs with non-slip rubber feet & over 30 setting combinations
- Lightweight portable aluminium construction weighing only 365g & compact space saving 36cm design.





...

  The Kenair Dust Vac Kit is supplied with a 360ml cartridge of Kenair, Re-usable Kenair Actuator Valve & Dust Vac Attatchment. Kenair is used to blow dust, fluff or other unwanted small particles from all types of precision equipment. Emitting a powerful jet it is used extensively in the photographic, movie, computer, electronics & general servicing industries. Kenair is used in standard “ blowing mode” with the Standard Actuator Valve which is provided with the kit. Also included is the Dust Vac attatchment. This is fitted within seconds onto the Actuator valve & converts it to highly effective Vaccum mode. This will vaccum off dust & other small particles & is particularly useful in applications where Air Dusters are not recommended, for example in Digital Camera applications. The Dust Vac attatchment is supplied with a soft ended 50cm pick up tube. Kenair is a safe dry gas CFC and HCFC free & complies with all EC regulations. When the Kenair Cartridge is finished, replace with a spare cartridge code KENRO02 ...

The DUST-CLOTH’s are designed to be used with the DUST-WAND & ULTRA CLEAN in the removal of light oils & the dislodging of welded-on dust. These non woven wipes are manufactured & packaged within a clean room environment. • Extra soft non woven wipes • 99.999% clean • Lint free • 50 count, 4”x 4” wipes • Comes in zip lock bag ...

DUST-CLOTH MF’s are made from a very soft weave of micro fiber cloth that has been tested repeatedly not to scratch sensor filters or their coatings. The main benefit to these micro fiber wipes is that they are designed not to produce loose fibers.  The sides of the wipes are heat sealed so fibers can't break free. Seeing that when wrapped you are only using the center part of the wipe, the sealed edge will not come close to the sensor filter. The Dust-Cloth MF wipes are also more absorbent than regular non-woven wipes which helps to reduce excess cleaning fluid escaping the wipe & seeping under the sensor filter frame. These wipes are sized 3"x 3" due to their thickness. This is plenty of cloth to produce a nice wrap & still have a good sight path to the sensor filter. ...

This wet do-it-yourself wrapping kit is a very cost effective way to clean welded-on dust from your entire collection of DSLR camera bodies. The versatility comes from the three included DUST-WAND's needed to clean any sensor aspect ratio, 1.6 (14mm), 1.3 (16mm) & 1.0 (18mm). When it comes to cleaning liquid evaporation speed, then there is non faster than ULTRA CLEAN™. This non-flammable & non-alcohol based liquid is one of the fastest dissolving liquids on the planet, which makes it virtually impossible for it to seep under the sensor filter frame. Also included are small cloth clips that are used to hold the cleaning wipe in place. No more having to carry around a roll of tape to hold the wrap, now you can just throw on a clip & the cloth will stay in place. With the kit comes DUST-CLOTHs™, our non woven wipes. There are 50 cloths per kit which come in a zip lock bag to keep them clean. To round out the kit you will also receive a travel friendly hard plastic case which everything fits in. 1 x DUST-WAND 1.6 (14mm) 1 x DUST-WAND 1.3 (16mm) 1 x DUST-WAND 1.0 (18mm) 1 x ULTRA CLEAN Liquid 3 x Cloth Clips 50- 4"x 4" DUST-CLOTH 1 x ZIP LOCK BAG  ...