Paslode 3.1mm x 63mm IM90 Ring Shank Nails Galv Plus 2, 500
- 2 Fuel Cells Paslode IM90 Diamond point Roun Drive nails, a unique off-sentre 34 Round head Nail packs with paper strip collation, supplied with Paslode Special Impulse gas fuel cells. FINISH: All Paslode nails are Chrome 6, cadmium & lead free & are available in five finishes to meet corrosion requirements. Bright: Economy & bright nails meet the Eurocode 5 requirements for applications in service class 1 (indoor)
Specification
- No coating. Galv Plus: Meet the Eurocode 5 requirements for applications in service class 1 & 2 (indoor & covered outdoor)
Specification
- Zn / Al alloy approx 15µm. Electro Galv: Meet the Eurocode 5 requirements for all applications in service class 1 & 2 (indoor & covered outdoor)
Specification
- Zn & chromate minimum 7µm. Hot Dipped Galv: Meet the Eurocode 5 requirements for all applications in service class 1, 2 & 3 (indoor, covered outdoor & outdoor)
Specification
- Zinc coating minimum 50µm Stainless Steel: Meet the Eurocode 5 requirements for all applications in service class 1, 2 & 3 (indoor, covered outdoor & outdoor)
Specification
- A2 according to AISI 304, & A4 according to AISI 316. SHANK: Smooth Shank: The standard nail, offering high shear value & lowest withdrawal resistance. Fixing across the grain. Fixing into end grain. Clenching applications.
Specification
- Number of centres will vary with shank diameter. Unilock Shank: Increases withdrawal resistance. Drives easier than ring shank fixing across the grain.
Specification
- The ringed parts have 24 rings per inch. Ring Shank: Provides the highest withdrawal resistance. Fixing across the grain.
Specification
- RPI (Rings Per Inch) vary from 16 to 32 depending on
Specification. HEAD TYPES: Round Head: The head area is designed to maximise resistance to the head being pulled through
Specification
- Head size between 2.0 & 2.5 times wire diameter according to EC5 Clipped Head: Increases number of nails per strip. The head area is designed to maximise resistance to the head being pulled through
Specification
- Head area corresponding to full round head area, according to EC5