The gigabit Power over Ethernet splitter, model TPE-114GS, is used to install non-Po E devices in remote locations. It splits a networked Po E signal into separate power & gigabit data sources. Run an Ethernet cable from a gigabit Po E switch (or injector) for distances up to 100 meters & then split the Po E signal into separate gigabit data & power sources in order to network a non-Po E device. No need to install non-Po E devices near a power outlet. Save installation & equipment cost when installing access points, IP cameras, & more in a remote location. This compact splitter safeguards valuable network equipment with short circuit protection. Quickly create an integrated Po E & non-Po E network at gigabit speeds.