Kingston 4GB (2x2GB) HyperX DDR3 1600MHz DIMM XMP X2 CL9 (Genesis
Special Edition Grey)

Product Description

**4GB (2GB 256M x 64-Bit x 2 pcs.) DDR3-1600 M Hz CL9 240-Pin DIMM Kit** Kingstons KHX1600C9D3X2K2/4GX is a kit of two 256M x 64-bit 2GB (2048MB) DDR3-1600 M Hz CL9 SDRAM (Synchronous DRAM) memory modules, based on sixteen 128M x 8-bit DDR3 FBGA components per module. Each module kit supports Intel XMP (Extreme Memory Profiles). Total kit capacity is 4GB. Each module kit has been tested to run at DDR3-1600 M Hz at a low latency timing of 9-9-9-27 at 1.65V. The SPDs are programmed to JEDEC standard latency DDR3-1333 M Hz timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers & requires +1.5V. ** Features**
- JEDEC standard 1.5V ± 0.075V Power Supply
- VDDQ = 1.5V ± 0.075V
- 667 M Hz f CK for 1333 Mb/sec/pin
- 8 independent internal bank
- Programmable CAS Latency: 5, 6, 7, 8, 9, 10
- Posted CAS
- Programmable Additive Latency: 0, CL
- 2, or CL
- 1 clock
- Programmable CAS Write Latency (CWL) = 7 (DDR3-1333)
- 8-bit pre-fetch
- Burst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with t CCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
- Bi-directional Differential Data Strobe
- Internal (self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm ± 1%)
- On Die Termination using ODT pin
- Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
- Asynchronous Reset
- PCB: Height 1.180" (30.00mm), double sided component