Capless cooling system tester uses an inflatable bladder to seal the pressure head to the radiator or header tank. Bladder system can be used on both screw & bayonet fittings & seals 90% of cars & light commercial vehicles straight out of the box. Also suitable for motorcycles, off-road & marine applications. Supplied with set of double end adaptors enabling testing of cooling system pressure caps. Supplied in carry-case. Model No. VS0031 ...

Eliminates the introduction of bubbles & air-locks into the cooling system & dramatically reduces system filling time. No more time-consuming system bleeding. Reduces fluid waste & messy spills. Automatically conducts system leak test. Low profile design broadens application range especially for use on MPVs where lower windscreen lip might obstruct other tools. Simple operation requires workshop air supply & does not require fiddly interchange of vacuum & fluid hoses
- as found on other versions of this tool. Supplied with 1300mm fluid hose. Model No. VS0041
...

Updated kit which

Includes:: two new caps suitable for newer Ford & Vauxhall/ Opel vehicles. Heavy-duty pressure

...

Traditional style cooling system pressure testing kit. Features five new adaptors increasing the vehicle applications. Suitable for Alfa, Audi, BMW, Chrysler, Citroen, Daewoo, Fiat, Ford, Honda, Hyundai, Kia, Lancia, Mazda, Mercedes, Mitsubishi, Nissan, Peugeot, Renault, Rover, Saab, Seat, Skoda, Suzuki, Toyota, Vauxhall/ Opel, Volvo, VW. Also

Includes:: non-specific adaptors for other makes. Also

Includes:: non-specific adaptors for other makes. Locates system leaks from: - Head gasket - Header tank - Radiator & heater cores - Water pumps, hoses & housings Kit features adaptors fitted with quick-release couplings & high-powered pump with large, easy-to-read dial. The kit is packed in a large carry-case & is supplied with operating instructions.



...

Capless tester uses cone adaptor system to seal & pressurise the cooling system. Adaptors may be used to replace both screw & bayonet type cap fittings. Kit

Includes:: pump with gauge & four system adaptors for use on a wide range of vehicle applications. Model No. VS0033

...

Dramatically reduces cooling system refill time, without mess & without introducing air-locks. No more time consuming cooling system bleeding & no more messy spills to clean up. Simply plug into the workshop air line, attach to the cooling system header tank & create a vacuum. Complete the process by attaching the filler hose & opening the valve allowing your pre-mixed coolant to flow into the system Supplied with three adaptors & carry-case. Model No. VS0042 ...

Soft touch composite casing with comfortable ergonomic hand grip. Features 12 super bright SMD LEDs producing up to 400 lumens output. 2 Selectable modes of brightness. Fitted with 360° swivel hook & rear magnet for hands free applications. Charge indicator flashes green & red when fully charged. Supplied with mains charger, in-car charger & stand for free-standing use. Model No. LED026 ...

Featuring 26 super bright LEDs, 21 used as an inspection lamp or 5 in the end for use as a directional torch. Two 360° swivel hanging hooks for hands-free applications allowing unit to be used horizontally or vertically. Three rubber covered magnets for protection against accidental damage, two magnets on the rear of the lamp for horizontal use & one on the end for vertical use. Bottom quarter of the lamp rotates 180° allowing the unit to be positioned for ease of use on any ferrous surface. Replaceable shatterproof polycarbonate lens with a highly polished reflector board gives an increased spread of light. Lithium-ion polymer battery (3.7V/1200m Ah) for longer life, no memory effect, a much slower discharge than typical Ni-MH batteries & can operate for up to four hours on a single charge. Supplied with mains & in-car chargers. Model No. LED2105 ...

Featuring 26 super bright LEDs, 21 used as an inspection lamp or 5 in the end for use as a directional torch. Two 360° swivel hanging hooks for hands-free applications allowing unit to be used horizontally or vertically. Three rubber covered magnets for protection against accidental damage, two magnets on the rear of the lamp for horizontal use & one on the end for vertical use. Bottom quarter of the lamp rotates 180° allowing the unit to be positioned for ease of use on any ferrous surface. Replaceable shatterproof polycarbonate lens with a highly polished reflector board gives an increased spread of light. Lithium-ion polymer battery (3.7V/1200m Ah) for longer life, no memory effect, a much slower discharge than typical Ni-MH batteries & can operate for up to four hours on a single charge. Supplied with mains & in-car chargers. Model No. LED2105F ...

Featuring 26 super bright LEDs, 21 used as an inspection lamp or 5 in the end for use as a directional torch. Single LED battery indicator. Two 360° swivel hanging hooks for hands-free applications allowing unit to be used horizontally or vertically. Three rubber covered magnets for protection against accidental damage, two on the rear of the lamp for horizontal use & one on the end for vertical use. Bottom quarter of the lamp rotates 180° allowing the unit to be positioned for ease of use on any ferrous surface. Replaceable shatterproof polycarbonate lens with a highly polished reflector board gives an increased spread of light. Lithium-ion polymer battery (3.7V/1200m Ah) for longer life, no memory effect, a much slower discharge than typical Ni-MH batteries & can operate for up to four hours on a single charge. Supplied with mains & in-car chargers. Model No. LED2105G ...