Fi-Clor p H Increaser (Soda Ash) is for raising the p H level in swimming pool water. p H is a measure of how acid or how alkaline the water is. Low p H can lead to skin irritation & corrosion of equipment. Instructions to correct p H > Take a p H reading using your test kit or test strips. You will need to raise the p H if the reading is below 7.2. > Pre-dissolve the Fi-Clor p H Increaser in pool water using a suitable container. In order to avoid concentrated solutions, only dissolve a maximum of 500g of the product in 10 litres of water at a time, adding product to water, never water to product. If you need to use more than 500g Fi-Clor p H Increaser repeat the treatment. Dose no more than a total of 1kg at a time. > With the circulation system running, distribute evenly around the pool, avoiding the skimmers. > Continue filtration & re-test after 24 hours. If the p H is still low, repeat the dose. ...

5 Actions in only one treatment. Fi-Clor Premium 5 Granular is specially formulated to out-perform standard chlorine granules,

...

5 Actions in only one treatment. Fi-Clor Premium 5 Granular is specially formulated to out-perform standard chlorine granules,

...

5 Actions in only one treatment. Fi-Clor Premium 5 Tablets are specially formulated to out-perform standard 200g trichlor tablets,

...

5 Actions in only one treatment. Fi-Clor Premium 5 Tablets are specially formulated to out-perform standard 200g trichlor tablets,

...

Fi-Clor Stain & Scale Inhibitor has been specially developed to help prevent staining by dissolved minerals, especially where

...

The make up of the mains water supply can vary considerably across the country; you may even have a non-mains source such as spring or well water. As a result, different levels of p H, total alkalinity, calcium hardness & mineral content will be found in the water that you fill your spa with. In hard water areas of the UK or if there is a high mineral content, it is strongly recommended that Fi-Clor Spa Anti-Scale is added when your spa is initially filled with fresh water & also every time it is topped up or refilled after periodic draining. This should help to minimise scale formation & staining of the spa surfaces. ...

The circulation/filtration system consists of a circulating pump & filter; the pump moves the water through the system. The filter removes small particles, which if left in the water would turn the water turbid. It's important to follow the manufacturer ...