Permasoft Soft Denture Lining

Product Description

Permasoft Soft Denture Lining Loose dentures can cause a range of health problems including sores & infections, aside from discomfort & embarrassment, & can make daily activities such as talking & eating more difficult. Permasoft Soft Denture Lining eliminates these problems by constantly adapting to fit the contours of your gum, forming a soft flexible cushion that holds your dentures securely in place, even if your gums change. Permasoft Soft Denture Lining is also great for sore gums that cannot stand a hard plastic denture & for helping to reduce irritation & sore spots caused by rubbing. Permasoft Soft Denture Lining is simple, convenient & economical. Each application lasts up to 3 months, & once applied, you should not need to use a daily fixative. As it simply helps to re-shape the fit of your denture to your mouth, you can still remove your dentures as normal. Permasoft Soft Denture
Lining: Lasts for up to 3 months per application. Is suitable for full & partial dentures. Makes a pefect impression, giving perfect fit & suction. Is easy to apply. Is safe & hygienic. Is completely free from zinc. Contents 1 x blue plastic spatula.2 x tubes of white powder.1 x bottle of clear liquid plasticiser.1 x recycled plastic mixing dish. Easy to follow instructions. Directions Follow these easy steps for perfect fit & suction of your denture. Fit one denture at a time. Never fit both dentures at the same time. Clean & dry denture thoroughly: Clean your denture as normal using a brush & denture cleaner. Rinse & make sure to dry thoroughly. Mix the powder & liquid: Carefully tap the contents of one of the tubes of white powder into the removable mixing tray. Next remove the cap from the liquid bottle. Fill the cap with the liquid & pour into the white powder in the mixing tray. Mix together with the spatula provided until a smooth paste is obtained. Fit the upper denture: Using the spatula, immediately spread the mixture evenly over the entire fitting surface. Fit the denture in mouth: When the mix is soft & malleable insert the denture into your mouth. Use your thumbs to push it firmly into place. Close your mouth gently into your normal bite position, remaining there for not less than 2 minutes. To ensure that the right contour & a good fit is obtained use your mouth muscles by pulling your lips backwards & forwards, as if smiling & gently chewing. Do not bite too hard. Remove surplus

Material: You only need to complete the exercises detailed in step 4 for about 2 minutes but we recommend leaving your denture in for a further 8 minutes to ensure a perfect fit. After this remove the denture & rinse both your mouth & denture in warm water. Check that the fitting surface is sufficiently covered with Permasoft, especially at the edges. Remove excess material using a sharp knife or razor, taking care not to disturb the rolled edge of the material. Repeat procedure for lower denture (at this stage you can re-use the removable mixing tray or the circular section of the mixing tray, whatever is easiest for you). Partial Dentures To tighten partial dentures, clean & dry denture thoroughly & then place a small amount of material on contact points, i.e. the part of the denture that rests against the natural tooth. Wait one minute then place denture in mouth. To remove Permasoft Place the denture in very hot (not boiling) water & gently pull away material. Caution Permasoft is an effective denture aid & is intended only to hold dentures comfortably & securely until your next dental visit.